Dacia Pick-Up 1304/1305/1307. Manual — part 135
INSTRUMENT PANEL
83
83 - 12
FUEL LEVEL INDICATOR NOT OPERATING
Place at mass the connection wire to the
probe.
The indicator does not work;
Replace the probe.
The indicator does not work.
Check the indicator supply and
mass.
Not correct. Repair the mass wiring or
probe supply.
Iff correct. Place at mass the
connection wire to the probe.
Indicator does not work.
Repair the wiring between the probe and indicator.
DIAGNOSTIC
83
INSTRUMENT PANEL
83 - 13
Dismounting of the speedometer cable does not imply the dismounting of the instrument panel
from the dashboard.
DISMOUNTING
Push in the direction of A and B arrows, then pull in the C direction.
Loosen the attachment screw E at the gearbox and pull the cable.
Detach the cable from the attachment clips on the longitudinal girder.
REMOUNTING
Center the speedometer cable in the instrument panel socket, then push in the direction of D
arrow, until a “click” is heard, confirming the coupling.
Center the cable in the speedometer endless screw, tighten the screw and lock it with the
locking nut.
Position it in the attachment clips of the longitudinal girder, observing the curve. (R min = 150 mm).
FLEXIBLE CABLE
A
B
C
D
E
INSTRUMENT PANEL
83
83 - 14
NOTE:
The oil pressure switch may not be repaired. It is placed on the left side of the engine
block.
To check the oil pressure switch, the
following items are required:
- a compressed air source;
- a 0 – 1 bars manometer;
- a control lamp.
Make an assembly according to the
diagram. When the air is off, the control lamp
should be lighted. If the lamp does not light,
replace the oil pressure switch.
When the air is open and the pressure is
over 0,35 +/- 0,08 bars, the control lamp
should go off.
If the lamp does not go off at all, or does
not go off at the required pressure, replace
the oil pressure switch.
OIL PRESSURE SWITCH CHECKING
83
INSTRUMENT PANEL
83 - 15
THERMOCOUPLE CHECKING
NOTE: The thermocouple may not be repaired. It is located on closing plate of the
cylinder head.
In order to check the thermocouple, there
are necessary : a vessel with cooling liquid(
antifreeze + distilled water ), a
0 – 200 ° C
thermometer, a control lamp, a
heat source.
Make an assembly according to the
diagram.
When the temperature of the fluid is low,
the control lamp should be off. If the lamp is
on, replace the thermocouple.
Warm up the fluid in the vessel. When the fluid temperature reaches the temperature required
for the thermocouple contact ( 180 ° C) the control lamp should be lighted.If the lamp does not
light up, replace the thermocouple.
The coupling temperature is marked on the thermocouple body.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст