Dacia Pick-Up 1304/1305/1307. Manual — part 71
FRONT BEARING ELEMENTS
31 - 8
31
CHECKING
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Lower arm checking device
PF 502
Dynamometric wrench
MOT 50
LOWER ARM
Dismount the suspension lower arm.
Mount the lower arm checking device PF 502 on the lower arm and introduce the shaft.
By means of the pin (D) placed on the arm, measure the distance between the pins
(A,B,C) and arm, which should be between 0 and 1 mm .
Mount the suspension lower arm on the vehicle.
31
FRONT BEARING ELEMENTS
31 - 9
ELASTIC BUSHING, LOWER ARM BALL JOINT
ELASTIC BUSHING REPLACEMENT
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Dynamometric wrench
MOT 50
This operation implies bushings replacement one by one ,in order to maintain their
position as to the arm shaft.
Dismount the suspension lower arm.
Depress one elastic bushing, using a 31 mm outside diameter (D) rod.
Mount the new bushing on a press ,observing the value A = 151 mm.
Dismount on a press the other elastic bushings.
Press the new bushing ,observing the value A = 151mm.
Mount the suspension lower arm on the vehicle.
FRONT BEARING ELEMENTS
31 - 10
31
BALL JOINT REPLACEMENT
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Dynamometric wrench
MOT 50
Release the ball joint by means of the
PF 476 extractor.
Dismount the suspension lower arm.
Bore and remove the ball joint attachment
rivets.
Mount the new ball joint and attach it with
screws, which shall have the head oriented
towards the bellows.
Mount the lower arm on the vehicle.
Check and adjust:
- the caster angle;
- the camber angle;
- the steering box position;
- the parallelism and repartition.
ELASTIC BUSHING, LOWER ARM BALL JOINT
31
FRONT BEARING ELEMENTS
31 - 11
BRAKE GASKETS
SPECIAL
TO O LS
: Pushing piston device FR 500
FRONT BRAKE PADS REPLACEMENT
NOTE:
In order to maintain the brake efficiency, the replacement of the brake pads shall be
made only in complete kit; never fit brake pads of different makes and different
qualities.The replacement is made when the pad thickness is less than 7 mm (support
included).
D
ISMO UNTING
Lift the vehicle by means of a two columns elevator.
Dismount the wheels.
Dismount the calipers without detaching the flexible hoses.
NOTE:
Do not press the brake pedal
Dismount :
- the brake pads;
- elastic blades.
Dismount the protection bellows.
Clean with alcohol the housing of bellow and the piston end; blow with compressed air.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст