Daewoo Nubira. Manual — part 21
9N – 4
I
FRAME AND UNDERBODY
DAEWOO V–121 BL4
4. Install the front fascia splash shield with the screws.
Tighten
Tighten the front fascia splash shield screw to 1.5
N
S
m (13 lb–in).
5. Lower the vehicle.
FRAME AND UNDERBODY 9N – 5
DAEWOO V–121 BL4
GENERAL DESCRIPTION
AND SYSTEM OPERATION
GENERAL BODY CONSTRUCTION
This vehicle is constructed with a unitized body which in-
corporates integral front and rear frame side rails.
The front suspension lower control arms are bolted to and
retained by supports, one each on the right and left sides.
The front suspension lower control arm supports are at-
tached to the underbody with three bolts at two locations.
The engine is bolted to the integral front side rails. The
suspension strut towers must be dimensionally correct in
relation to the remainder of the underbody in order to main-
tain specified suspension strut and caster/camber angles.
Since the individual underbody parts contribute directly to
the overall strength of the body, it is essential to observe
proper welding techniques during service repair opera-
tions. The underbody parts should be properly sealed and
rustproofed whenever body repair operations destroy or
damage the original sealing and rustproofing. When rust-
proofing critical underbody parts, use a good–quality type
of air–dry primer, such as a corrosionresistant chromate
or an equivalent material. Combination–type primer/sur-
facers are not recommended.
ENGINE UNDER COVERS
The engine under covers are molded pieces of plastic that
serve as shields for the underside of the engine. The cov-
ers help protect the engine from small rocks, gravel and
other objects that would otherwise come into contact with
the engine during normal driving conditions.
SECTION : 9P
DOORS
CAUTION : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool
or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable will help
prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.
TABLE OF CONTENTS
SPECIFICATIONS
9P–1
. . . . . . . . . . . . . . . . . . . . . . . . . .
FASTENER TIGHTENING SPECIFICATIONS
9P–1
.
SCHEMATIC AND ROUTING DIAGRAMS
9P–3
. . . . .
POWER DOOR LOCKS
9P–3
. . . . . . . . . . . . . . . . . . . .
POWER WINDOWS ((FRONT AND REAR))
9P–4
. .
DIAGNOSIS
9P–5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
POWER DOOR LOCKS
9P–5
. . . . . . . . . . . . . . . . . . . .
POWER WINDOWS (FRONT AND REAR)
9P–7
. . .
MAINTENANCE AND REPAIR
9P–9
. . . . . . . . . . . . . . .
ON–VEHICLE SERVICE
9P–9
. . . . . . . . . . . . . . . . . . . . .
FRONT DOOR GLASS RUN
9P–9
. . . . . . . . . . . . . . . .
REAR DOOR GLASS RUN
9P–9
. . . . . . . . . . . . . . . . .
FRONT DOOR SECONDARY WEATHERSTRIP 9P–
11
REAR DOOR SECONDARY WEATHERSTRIP 9P–11
DOOR LOCK STRIKER
9P–12
. . . . . . . . . . . . . . . . . . .
DOOR LOCK STRIKER ADJUSTMENT
9P–13
. . . . .
FRONT DOOR LOCK
9P–14
. . . . . . . . . . . . . . . . . . . . .
CHILDPROOF REAR DOOR LOCK
9P–17
. . . . . . . . .
INSIDE DOOR HANDLE
9P–19
. . . . . . . . . . . . . . . . . .
INSIDE LOCK ROD
9P–19
. . . . . . . . . . . . . . . . . . . . . . .
OUTSIDE DOOR HANDLE
9P–20
. . . . . . . . . . . . . . . .
DOOR LOCK CYLINDER
9P–21
. . . . . . . . . . . . . . . . . .
POWER FRONT WINDOW REGULATOR
9P–21
. . .
POWER REAR WINDOW REGULATOR
9P–23
. . . .
MANUAL REAR WINDOW REGULATOR
9P–24
. . . .
MANUAL REAR WINDOW REGULATOR HANDLE 9P
–25
FRONT DOOR ASSEMBLY
9P–25
. . . . . . . . . . . . . . . .
REAR DOOR ASSEMBLY
9P–27
. . . . . . . . . . . . . . . . .
DOOR HINGE
9P–29
. . . . . . . . . . . . . . . . . . . . . . . . . . .
DOOR HOLD OPEN LINK
9P–29
. . . . . . . . . . . . . . . . .
INSIDE CHANNEL MOLDING
9P–30
. . . . . . . . . . . . . .
OUTSIDE CHANNEL MOLDING
9P–31
. . . . . . . . . . .
DOOR WEATHERSTRIP
9P–31
. . . . . . . . . . . . . . . . . .
DOOR SEAL TRIM
9P–32
. . . . . . . . . . . . . . . . . . . . . . .
FRONT DOOR OPENING WEATHERSTRIP
9P–33
.
REAR DOOR OPENING WEATHERSTRIP
9P–34
. .
GENERAL DESCRIPTION AND SYSTEM
OPERATION
9P–35
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DOOR LOCK STRIKER
9P–35
. . . . . . . . . . . . . . . . . . .
CHILDPROOF REAR DOOR LOCK
9P–35
. . . . . . . . .
POWER DOOR LOCKS
9P–35
. . . . . . . . . . . . . . . . . . .
POWER WINDOWS
9P–35
. . . . . . . . . . . . . . . . . . . . . .
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Application
N
S
m
Lb–Ft
Lb–In
Door Hinge Bolts
25
18
–
Door Hold Open Link–to–
Body Bolt
27
20
–
Door Hold Open Link–to–
Door Bolts
6
–
53
Door Lock Striker Screws
10
–
89
Door Pull Bracket Screws
3.5
–
31
9P – 2
I
DOORS
DAEWOO V–121 BL4
Application
Lb–In
Lb–Ft
N
S
m
Front and Rear Door Lock
Screws
10
–
89
Inside Door Handle Screw
1.5
–
13
Outside Door Handle Bolts
4
–
35
Rear Door Exterior Garnish
Molding Screws
1.5
–
13
Window Regulator Nuts
8
–
71
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст