Daewoo Nubira. Manual — part 26
DOORS 9P – 19
DAEWOO V–121 BL4
INSIDE DOOR HANDLE
Removal Procedure
1. Remove the door seal trim. Refer to”Door Seal
Trim” in this section.
2. Remove the screw securing the door handle to the
door.
3. Slide the door handle forward and remove it from
the door.
4. Disconnect the inside door handle and the lock
rods.
Installation Procedure
1. Connect the inside door handle and the lock rods.
2. Insert the inside door handle into the slots in the
door.
3. Slide the door handle rearward.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
4. Install the inside door handle screw.
Tighten
Tighten the inside door handle screw to 1.5 N
S
m (13
lb–in).
5. Install the door seal trim. Refer to”Door Seal Trim”
in this section.
INSIDE LOCK ROD
Removal Procedure
1. Remove the door seal trim. Refer to”Door Seal
Trim” in this section.
2. Disconnect the inside lock rods from the door han-
dle and the lock.
9P – 20
I
DOORS
DAEWOO V–121 BL4
Installation Procedure
1. Connect the inside lock rods to the door handle and
the lock.
2. Install the door seal trim. Refer to”Door Seal Trim”
in this section.
OUTSIDE DOOR HANDLE
Removal Procedure
1. Remove the door seal trim. Refer to”Door Seal
Trim” in this section.
2. Disconnect the outside door handle and the lock
rods.
3. Remove the bolts and the door handle.
Installation Procedure
1. Connect the outside door handle and the lock rods.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the door handle with the bolts.
Tighten
Tighten the outside door handle bolts to 4 N
S
m (35
lbin).
3. Install the door seal trim. Refer to”Door Seal Trim”
in this section.
DOORS 9P – 21
DAEWOO V–121 BL4
DOOR LOCK CYLINDER
Removal Procedure
1. Remove the door seal trim. Refer to”Door Seal
Trim” in this section.
2. Disconnect the outside door handle lock rod.
3. Remove the retaining clip and the lock cylinder.
Installation Procedure
1. Install the lock cylinder with the retaining clip.
2. Connect the outside door handle lock rod.
3. Install the door seal trim. Refer to”Door Seal Trim”
in this section.
POWER FRONT WINDOW
REGULATOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front door glass. Refer to Section 9L,
Glass and Mirrors.
3. Disconnect the electrical connector.
9P – 22
I
DOORS
DAEWOO V–121 BL4
4. Remove the nuts and the regulator.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the window regulator with the nuts.
Tighten
Tighten the window regulator nuts to 8 N
S
m (71 lb–in).
2. Connect the electrical connector.
3. Install the front door glass. Refer to Section 9L,
Glass and Mirrors.
4. Connect the negative battery cable.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст