Daewoo Nubira. Manual — part 12
9S – 6
I
BODY REAR END
DAEWOO V–121 BL4
Installation Procedure
1. Install the spring into the hinge mount.
2. Extend the spring to mount it in the rear mounting
hole.
LUGGAGE COMPARTMENT LOCK
CYLINDER
(Notchback Shown, Hatchback and
Wagon Similar)
Removal Procedure
1. Remove the lower garnish molding (hatchback and
wagon only).
2. Remove the nuts that secure the lock cylinder.
3. Disconnect the lock rod.
4. Remove the luggage compartment lock cylinder.
Installation Procedure
1. Install the luggage compartment lock cylinder.
2. Connect the lock rod.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
3. Secure the luggage compartment lock cylinder with
the nuts.
Tighten
Tighten the luggage compartment lock cylinder nuts
to 4 N
S
m (35 lb–in).
4. Install the lower garnish molding (hatchback and
wagon only).
BODY REAR END 9S – 7
DAEWOO V–121 BL4
LUGGAGE COMPARTMENT LOCK
STRIKER (NOTCHBACK)
Removal Procedure
1. Open the luggage compartment.
2. Remove the bolts securing the lock striker.
3. Pull the lock striker out.
4. Disconnect the lock release cable from the lock
striker.
Installation Procedure
1. Connect the lock release cable.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the lock striker with the bolts.
Tighten
Tighten the luggage compartment lock striker bolts to
8 N
S
m (71 lb–in).
LUGGAGE COMPARTMENT LOCK
(NOTCHBACK AND HATCHBACK)
(Notchback Shown, Hatchback
Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the lock trim cover (hatchback only).
3. Disconnect the electrical connector.
9S – 8
I
BODY REAR END
DAEWOO V–121 BL4
4. Remove the screws and the luggage compartment
lock.
5. Disconnect the lock rod.
Installation Procedure
1. Connect the lock rod.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the luggage compartment lock with the
screws.
Tighten
Tighten the luggage compartment lock screws to 6
N
S
m (53 lb–in).
3. Connect the electrical connector.
4. Install the lock trim cover (hatchback only).
5. Connect the negative battery cable.
BODY REAR END 9S – 9
DAEWOO V–121 BL4
WEATHERSTRIP
(Notchback Shown, Hatchback
Similar)
Removal Procedure
1. Open the luggage compartment lid.
2. Remove the weatherstrip from around the gutter.
Installation Procedure
1. Install the weatherstrip onto the gutter flange.
2. Inspect the weatherstrip. Make sure that the clinch
is completely seated onto the flange.
3. Using a water hose without a nozzle, test the rear
deck lid to make sure that no leaks are present.
S
If there are no leaks present, the weatherstrip
does not need to be held in place. No further
repair is required.
S
If leaks are present, continue with the remainder
of the installation procedure.
4. Remove the weatherstrip.
5. Install the new weatherstrip onto the gutter flange.
HATCHBACK DOOR
Removal Procedure
1. Open and suitably support the hatchback door.
2. Disconnect the hatchback door grommets, electri-
cal connectors, and washer hose.
3. Remove the gas support assemblies from the
hatchback door. Refer to”Gas Support Assemblies
(Hatchback)” in this section.
4. With the aid of another technician, remove the bolts
and the hatchback door from the hinges.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст