Daewoo Nubira. Manual — part 47
4G – 6
I
PARKING BRAKE
DAEWOO V–121 BL4
3. Remove the parking brake cable ends from the
equalizer.
4. Raise and suitably support the vehicle.
5. Remove the rear wheels. Refer toSection 2E, Tires
and Wheels.
6. Unfasten the parking brake cable from the lever at
the rear of the backing plate.
7. Remove the clip that holds the cable into the pro-
truding hole on the steering knuckle assembly.
8. Remove the nut securing the parking brake cable to
the underbody clip on both the driver and passen-
ger sides of the vehicle.
PARKING BRAKE 4G – 7
DAEWOO V–121 BL4
9. Remove the parking brake cable from the clip near
the fuel tank strap (passenger side).
10. Suitably support the fuel tank.
11. Remove the fuel tank retaining strap nut on the
driver’s side and remove the parking brake cable.
Pull the cable through the loop of the welded under-
body bracket.
12. Remove the parking brake cable and rubber grom-
met.
4G – 8
I
PARKING BRAKE
DAEWOO V–121 BL4
Installation Procedure
1. Route the cable to the hole on the steering knuckle
assembly.
2. Fasten the parking brake cable to the lever at the
rear of the disc brake backing plate.
3. Install the clip that secures the parking brake cable
to the routing hole on the steering knuckle assem-
bly.
4. Install the nut securing the parking brake cable to a
bracket on both the driver and passenger sides of
the vehicle.
Tighten
Tighten the parking brake cable–to–underbody side
bracket nuts to 12 N
S
m (106 lb–in).
5. Install the parking brake cable (passenger’s side) to
the clip near the fuel tank strap.
6. Route the parking brake cable through the loop of a
welded underbody bracket and under the fuel tank
retaining strap (driver’s side).
Tighten
Tighten the fuel tank retaining strap nut to 12.5 N
S
m
(111 lb–in).
PARKING BRAKE 4G – 9
DAEWOO V–121 BL4
7. Route the parking brake cables through the access
holes to the parking brake/gearshift console.
8. Install the rubber grommet for each cable.
9. Install the rear wheels. Refer toSection 2E, Tires
and Wheels.
10. Lower the vehicle.
11. Attach the parking brake cable ends to the equaliz-
er.
12. Attach the eye bolt pull rod to the parking brake
lever assembly and fasten the split pin.
13. Install the parking brake/gearshift console hood.
Refer toSection 9G, Interior Trim.
14. If the parking brake shoe lever was pressed back-
ward before removing the brake drum, now press it
forward and adjust the parking brake. Refer
to”Parking Brake Adjustment”in this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст