Daewoo Nubira. Manual — part 202
INTERIOR TRIM 9G – 9
DAEWOO V–121 BL4
HATCHBACK DOOR UPPER
GARNISH MOLDING
Removal Procedure
1. Remove the rear compartment security cover
mount.
2. Remove the screws and the molding.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the molding with the screws.
Tighten
Tighten the trim panel screws to 2 N
S
m (18 lb–in).
2. Install the rear compartment security cover mount.
9G – 10
I
INTERIOR TRIM
DAEWOO V–121 BL4
TAILGATE UPPER GARNISH
MOLDING (WAGON)
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the tailgate.
3. Remove the center high–mounted stop lamp ac-
cess cover.
4. Remove the screws and the molding.
5. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the molding with the screws.
Tighten
Tighten the trim panel screws to 2 N
S
m (18 lb–in).
3. Install the center high–mounted stop lamp access
cover.
4. Connect the negative battery cable.
HATCHBACK DOOR LOWER
GARNISH MOLDING
Removal Procedure
1. Open the hatchback door.
2. Remove the screws and the lower garnish molding
clips using the trim remover KM–475–B.
3. Remove the lower garnish molding.
INTERIOR TRIM 9G – 11
DAEWOO V–121 BL4
Installation Procedure
1. Install the lower garnish molding with the clips and
the screws.
Tighten
Tighten the trim panel screws to 2 N
S
m (18 lb–in).
2. Close the hatchback door.
KICK PANEL
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Reposition the front portion of the front rocker pan-
el.
2. Remove the kick panel screws.
3. Pry off the kick panel.
Installation Procedure
1. Install the kick panel.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the kick panel screws.
Tighten
Tighten the kick panel screws to 2 N
S
m (18 lb–in).
3. Install the front portion of the front rocker panel to
its original position.
9G – 12
I
INTERIOR TRIM
DAEWOO V–121 BL4
FOOTWELL UPPER COVER
Tools Required
KM–475–B Trim Remover
Removal Procedure
1. Remove the glove box. Refer toSection 9E, Instru-
mentation/Driver Information.
2. Remove the bolt and the floor console forward trim
panel.
3. Remove the right side kick panel. Refer to”Kick
Panel” in this section.
4. Remove the bolts from the footwell upper cover.
5. Using the trim remover KM–475–B, remove the
plastic retaining clips and the footwell upper cover.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст