Daewoo Nubira. Manual — part 59
4E – 6
I
REAR DISC BRAKES
DAEWOO V–121 BL4
3. Align the match marks that were made before re-
moval and install the rear wheels. Refer toSection
2E, Tires and Wheels.
4. Fill the master cylinder to the proper level with
clean brake fluid.
5. Bleed the caliper. Refer toSection 4A, Hydraulic
Brakes.or Section 4F, Antilock Brakes,if applicable.
6. Recheck the fluid level.
7. Repeatedly press the brake pedal to bring the pads
into contact with the rotor. Do not move the vehicle
until a firm pedal is obtained.
ROTOR
Removal Procedure
1. Raise and suitably support the vehicle.
2. To preserve wheel balance, mark the position of the
rear wheels relative to the wheel hubs and remove
the wheels. Refer toSection 2E, Tires and Wheels.
Notice : To prevent damage to the brake hose, do not
hang the caliper from the brake hose.
3. Remove the caliper. Refer to”Caliper”in this section.
4. Remove the caliper bracket.
5. Remove the rotor detent screw.
6. Remove the rotor.
REAR DISC BRAKES 4E – 7
DAEWOO V–121 BL4
Installation Procedure
1. Inspect the rotor. Refer to”Rotor Inspection”in this
section.
2. Install the rotor with the detent screw.
Tighten
Tighten the rotor detent screw to 4 N
S
m (35 lb–in).
3. Install the caliper bracket.
Tighten
Tighten the caliper bracket mounting bolts to 56 N
S
m
(41 lb–ft).
4. Install the caliper. Refer to”Caliper”in this section.
5. Align the match marks that were made before re-
moval, and install the rear wheels. Refer toSection
2E, Tires and Wheels.
6. Lower the vehicle.
SPLASH SHIELD/BACKPLATE AND
PARKING BRAKE LEVER
Removal Procedure
1. Remove the rotor. Refer to”Rotor”in this section.
2. Disconnect the parking brake cable from the brake
backplate operating lever.
4E – 8
I
REAR DISC BRAKES
DAEWOO V–121 BL4
3. Pry off the shaft dust cover.
4. Remove the spindle shaft castle nut.
5. Remove the wheel hub assembly from the spindle
shaft.
6. Remove the bolts that secure the splash shield/
backplate/ parking brake shoe assembly to the
steering knuckle.
7. Remove the splash shield/backplate/parking brake
shoe assembly from the steering knuckle.
REAR DISC BRAKES 4E – 9
DAEWOO V–121 BL4
8. Remove the screw that secures the parking brake
shoe hold–down spring assembly to the backplate.
9. Remove the parking brake shoe, sliding it away
from the actuation mechanism.
10. Remove the splash shield.
11. Remove and discard the adjuster screw and the
nut.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст