Daewoo Nubira. Manual — part 33
9Q – 12
I
ROOF
DAEWOO V–121 BL4
11. Install the left and the right A–pillar trim panels.
12. Install the clock. Refer to Section 9E, Instrumenta-
tion/ Driver Information.
13. Install the cargo area lamp (wagon only). Refer to
Section 9B, Lighting Systems
14. Install the interior courtesy lamp or the interior cour-
tesy lamp/power sunroof switch, if equipped. Refer
to Section 9B, Lighting Systemsor”Interior Courtesy
Lamp/Power Sunroof ControlSwitch”in this section.
15. Install the sun visor and the sun visor supports. Re-
fer to”Sun Visors” in this section.
16. Install the ticket holder. Refer to Section 9E, Instru-
mentation/ Driver Information.
17. Install the passenger assist handles. Refer to”Pas-
senger Assist Handles” in this section.
18. Install the headliner/sunroof molding, if equipped.
19. Connect the negative battery cable.
SUN VISORS
Removal Procedure
1. Remove the screw and the sun visor from the
headliner.
2. Remove the screw and the sun visor support from
the headliner.
ROOF 9Q – 13
DAEWOO V–121 BL4
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the sun visor support to the headliner with
the screw.
Tighten
Tighten the sun visor support screw to 2 N
S
m (18 lbin).
2. Install the sun visor to the headliner with the screw.
Tighten
Tighten the sun visor screw to 2 N
S
m (18 lb–in).
PASSENGER ASSIST HANDLES
Removal Procedure
1. Remove the plastic caps to reveal the assist handle
screws.
2. Remove the screws and the assist handle from the
headliner.
9Q – 14
I
ROOF
DAEWOO V–121 BL4
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the assist handle to the headliner with the
screws.
Tighten
Tighten the passenger assist handle screws to 3.5
N
S
m (31 lb–in).
2. Install the plastic caps over the assist handle
screws.
INTERIOR COURTESY LAMP/POWER
SUNROOF CONTROL SWITCH
Removal Procedure
1. Disconnect the negative battery cable.
2. Pry off the lamp lens.
3. Remove the screws and the lamp/power sunroof
control switch.
4. Disconnect the electrical connector.
ROOF 9Q – 15
DAEWOO V–121 BL4
Installation Procedure
1. Connect the electrical connector.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the lamp/power sunroof control switch with
the screws.
Tighten
Tighten the lamp/power sunroof control switch
screws to 4 N
S
m (35 lb–in).
3. Install the lamp lens.
4. Connect the negative battery cable.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст