Daewoo Korando. Manual — part 215
![](/vehicles/epme/havi/atorinofils/zcoulong.png)
FRONT DRIVE AXLE 3A-7
Removal & Installation Procedure
1. Be careful not to change the valve when connecting the
check valve and each hose.
2. Adjust the clearance between the retainer ring (5) and
locking hub (7) using the shim(6).
Notice
Shim thickness : 0.1, 0.2, 0.3, 0.5, 1.0 mm
Normal
Max. 0.2 mm
3. Tighten the auto locking hub cap bolt to the specified torque
and order.
Tightening Torque
50 - 60 Nm
![](/vehicles/epme/havi/atorinofils/zouna.png)
3A-8 FRONT DRIVE AXLE
STEERING KNUCKLE AND DRIVE SHAFT
1 Front Axle Inner Shaft
2 Front Axle Drive Shaft
3 Spring Washer
4 Bolt . . . . . . . . . . . . . .. 45-60 Nm
5 Steering Knuckle
![](/vehicles/epme/havi/atorinofils/fan.png)
FRONT DRIVE AXLE 3A-9
Removal & Installation Procedure
1. Remove the tire.
Installation Notice
Steel Wheel
Aluminum Wheel
Tightening Torque
80 - 120 Nm
110 - 130 Nm
2. Remove the autolocking hub vacuum hose.
3. With ABS
Remove the wheel speed sensor from the steering knuckle.
Installation Notice
4. Remove the mounting bolts and pull off the caliper assembly.
Installation Notice
Tightening Torque
6 - 8 Nm
Hose Bolt
Mounting Bolt
Tightening Torque
25 - 35 Nm
85 - 105 Nm
Notice
Be careful not to damage the brake hose.
![](/vehicles/epme/havi/atorinofils/cod.png)
3A-10 FRONT DRIVE AXLE
5.
With part time transfer case.
5-1. Remove the cover mounting bolts and pull off the cover.
Installation Notice
5-2. Remove the snap ring of the drive shaft and pull off the
hub body.
Notice
For assembly, adjust the clearance between the snap ring
and hub not to exceed 0.2 mm (Shim thickness : 0.1, 0.2,
0.3, 0.5, 1.0 mm).
Tightening Torque
50 - 60 Nm
6.
With full time transfer case
6-1. Detach the hub cap with screw driver and remove the
snap ring on drive shaft.
Installation Notice
Tightening Torque
2 - 4 Nm
5-3. Remove the screws and pull off the locking hub washer.
Installation Notice
Notice
For assembly, adjust the clearance between the snap ring
and hub not to exceed 0.2 mm (Shim thickness : 0.1, 0.2,
0.3, 0.5, 1.0 mm).
Tightening Torque
15 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст