Daewoo Korando. Manual — part 36
1B1-80 M162 ENGINE MECHANICAL
Tools Required
104 589 01 01 00 Spanner
Removal & Installation Procedure
1. Remove the chain tensioner (1).
2. Turn the exhaust camshaft to the camshaft rotating direction
using the wrench (4) and loosen the timing chain at upper
guide rail (2).
3. Pull out the upper guide rail pin from the guide rail (2).
4. Turn the exhaust camshaft to the opposite direction of
rotation using the wrench (4, special tool : 104 589 01 01
00).
5. Check for damages at the upper sliding rail and replace it if
necessary. Install the upper guide rail pin.
6. Install the chain tensioner.
Installation Notice
CYLINDER HEAD GUIDE RAIL
Preceding Work : Removal of cylinder head cover
1 Chain Tensioner
2 Upper Guide Rail
3 Upper Guide Rail Pin
4 Wrench (Special Tool)
Tightening Torque
Screw Plug
40 Nm
Tensioner Assembly
72 - 88 Nm
M162 ENGINE MECHANICAL 1B1-81
CRANKCASE GUIDE RAIL
Preceding Work : Removal of timing gear case cover
1 Guide Rail
2 Plastic Guide
3 Guide Rail Pin
4 Tensioning Rail
Removal & Installation Procedure
1. Put the assembly mark at the camshaft sprocket and the
timing chain with the paint (arrow).
2. Remove the exhaust camshaft sprocket.
3. Remove the guide rail (1) from the guide rail pin (3).
Notice
l
Replace the plastic guide (2) if damaged.
l
Connect the plastic guide (2) and the guide rail (1) by
aligning them accurately when installing.
4. Installation should follow the removal procedure in the
reverse order.
5. Check the camshaft timing position.
1B1-82 M162 ENGINE MECHANICAL
CRANKSHAFT SPROCKET
Preceding Work : Removal of oil pan
Removal of tensioning rail
Removal of crank case guide rail
6 Bolt (M8 x 20, 1 piece) / Washer . . .. 29-35 Nm
7 Oil Pump Sprocket
8 Oil Pump
9 Oil Pump Roller Chain
10 Timing Chain
1 Oil Pump Chain Tensioner
2 Oil Pump Chain Bushing
3 Oil Pump Chain Spring
4 Crankshaft Sprocket
5 Key
M162 ENGINE MECHANICAL 1B1-83
Tools Required
615 589 01 33 00 Puller
Removal & Installation Procedure
1. Put the assembly mark at the crankshaft sprocket (4) and
the timing chain (10) with the paint (arrow).
Installation Notice
Align the assembly marks on cranshaft sprocket and timing
chain. Also, align the assembly marks on camshaft sprocket
and timing chain when installing.
2. Unscrew the bolt (6) and remove the oil pump sprocket (7)
from the oil pump.
Installation Notice
Puller (04) 615 589 01 33 00
3. Remove the oil pump roller chain (9).
4. Remove the oil pump chain tensioner (1), oil pump chain
bushing (2), and the oil pump chain spring (3).
5. Remove the crankshaft sprocket (4) using the puller (04,
special tool).
Notice
l
Make sure not to lose the crankshaft pulley key(5) when
removing.
l
Install the crankshaft sprocket(4) after warming it up.
6. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
29 - 35 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст