Daewoo Korando. Manual — part 182
1F3-12 OM600 ENGINE CONTROLS
Test Procedure
1. Remove the fuel filter (1) and keep the filter not to be
damaged from running engine.
2. Remove the vacuum line (2) from ancillaries connection (3).
3. Connect the vacuum tester (4) to the ancillaries connection
(3).
Vacuum Tester 201 589 13 21 00
4 Run the engine at idle and check vacuum pressure after 30
sec.
Notice
If out of standard, replace the vacuum pump.
5. Remove the vacuum tester.
6. Connect the vacuum line to the ancillaries connection.
7. Install the fuel filter.
Standard
> 70 mbar
OM600 ENGINE CONTROLS 1F3-13
VACUUM PUMP
Preceding Work : Remove the poly V-belt
1 Bolt . . . . . . . . . . . . . . . 10Nm
2 Vacuum Pump
3 Vacuum Line (Ancillaries)
4 Vacuum Line (Brake Booster)
5 Gasket . . . . . . . . . . . . ... Replace
1F3-14 OM600 ENGINE CONTROLS
Removal & Installation Procedure
1. Remove the vacuum line (3, 4).
2. Remove the bolts (1) evenly.
Notice
If necessary, rotate the engine until the pressure on the
tappet of the vacuum pump is released.
3. Remove the vacuum pump (2).
4. Install the vacuum pump (2).
Tightening Torque
10 Nm
Notice
Clean the gasket residues of sealing surface of vacuum
pump and replace the gasket(5).
5. Connect the vacuum line (3, 4).
OM600 ENGINE CONTROLS 1F3-15
VACUUM UNIT REPLACEMENT
1 Bracket
2 Bolt
3 Vacuum Unit
4 Vacuum Line
5 Seal . . . . . . . . . . . .. Replace
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст