Daewoo Korando. Manual — part 275
MANUAL TRANSMISSION 5B-13
5. Pull out the clip from the bracket and remove the shift cable
and select cable.
6. Installation is reverse order of the removal.
Inspection Procedure
1. The shift lever should be positioned in neutral.
2. Apply liquid gasket on the cable contact surface.
3. Keep 130 mm between the center of the cable end-eye
and floor.
Notice
If necessary, adjust the adjust nut.
Standard
130 mm
5B-14 MANUAL TRANSMISSION
TRANSMISSION
Preceding Work : Removal of the shift control cable
1 Clutch Housing
2 Oil Filler Plug . . . . . . . . . . . 25 Nm
3 Transmission Assembly
4 Back-up Switch
5 Washer
6 Bolt . . . . . . . . . . . . . .. 77-87 Nm
7 Oil Drain Plug . . . . . . . . . . . 25 Nm
8 Bolt . . . . . . . . . . . . . .. 81-89 Nm
9 Washer
10 Front Propeller Shaft
11 Transfer Case Assembly
12 Speedometer Cable
13 Rear Propeller Shaft
14 Washer
15 Bolt . . . . . . . . . . . . . .. 70-80 Nm
16 Cross Member
17 Washer
18 Bolt . . . . . . . . . . . . . .. 21-35 Nm
19 Washer
20 Bolt . . . . . . . . . . . . . .. 62-93 Nm
21 Breather Hose
MANUAL TRANSMISSION 5B-15
Removal & Installation Procedure
1. Disconnect the negative terminal from the battery.
2. Lift up the vehicle and fix it safely.
3. Remove the drain plug from the transmission housing and
drain the oil. Reinstall the drain plug.
Installation Notice
Tightening Torque
25 Nm
4. Disconnect the back-up switch connector.
5. Remove the breather hose.
6. Remove the speedometer connector and other wiring
harnesses and connectors.
5B-16 MANUAL TRANSMISSION
7. Remove the front and rear propeller shafts from the
transmission.
Installation Notice
Tightening Torque
81 - 89 Nm
70 - 90 Nm
Front
Rear
8. Support the transmission on an suitable jack.
Unscrew the center mounting nuts and each sides
mounting bolts and remove the cross member.
Installation Notice
9. Unscrew the transmission mounting bolts.
Installation Notice
Tightening Torque (1)
Tightening Torque (2)
21 - 35 Nm
62 - 93 Nm
10. Move the transmission jack backward careful and
disengage the transmission input shaft from the engine.
Remove the transmission.
11. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
77 - 87 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст