Daewoo Korando. Manual — part 125
M161 ENGINE COOLING 1D2-7
COOLING FAN AND VISCOUS CLUTCH
1 Bolt (M6 X 14, 3 piece) . . . . . . ... 9-11 Nm
2 Cooling Fan
3 Viscous Clutch
4 Union Nut (Left Threaded Screw) ... 40.5-49.5 Nm
1D2-8 M161 ENGINE COOLING
Tools Required
111 589 02 01 00 Open End Wrench
111 589 00 40 00 Open End Wrench
Removal & Installation Procedure
1. Install the holder (special tool : 111 589 00 40 00) to the bolt
at the pulley as shown in the right figure to hold the pulley.
2. Remove the viscous clutch using an open end wrench
(special tool : 111 589 02 01 00).
Installation Notice
Notice
The union nut is left threaded screw.
3. Remove the 3 bolts (1) from the viscous clutch and remove
the cooling fan and the viscous clutch.
Installation Notice
Tightening Torque
40.5 - 49.5 Nm
Tightening Torque
9 - 11 Nm
Notice
You may change the procedure (2) and (3) if necessary.
4. Installation should follow the removal procedure in the
reverse order.
M161 ENGINE COOLING 1D2-9
COOLANT PUMP
Preceding Work : Removal of viscous clutch
1 Bolt (M6 X 45, 1 piece) . . . . . . ... 9-11 Nm
2 Bolt (M6 X 95, 1 piece) . . . . . . ... 9-11 Nm
3 Bolt (M6 X 25, 4 piece) . . . . . . ... 9-11 Nm
4 Bolt (M8 X 85, 2 piece) . . . . ... 20.5-20.5 Nm
5 Coolant Pump Housing
6 Bolt (M6 X 16, 4 piece) . . . . . . ... 9-11 Nm
7 Coolant Pump Pulley
8 Coolant Inlet Hose
9 Heater Hose
10 Coolant Bypass Hose
11 Gasket
1D2-10 M161 ENGINE COOLING
Tools Required
124 589 15 21 00 Tester
Removal & Installation Procedure
1. Drain the coolant.
2. Disconnect the coolant hoses (8, 9, 10).
3. Tak off the drive belt.
4. Unscrew the four bolts (6) from coolant pump pulley and
remove the pulley (7).
Installation Notice
Tightening Torque
9 - 11 Nm
22.5 - 27.5 Nm
(1, 2, 3)
(4)
Notice
Hold the pulley with special tool (603 589 00 40 00) while
removing the pulley.
Tightening Torque
9 - 11 Nm
5. Unscrew the bolts (1, 2, 3, 4) from coolant pump housing
(5) and remove the coolant pump.
Installation Notice
6. Clean the sealing surface.
7. Replace the gasket with new one.
Notice
Apply the sealant when the sealing surface of coolant pump
housing and coolant mounting area is clean.
8. Installation should follow the removal procedure in the
reverse order.
9. Check for leaks by starting the engine.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст