Daewoo Musso. Manual — part 37
1B1-84 M162 ENGINE MECHANICAL
Tools Required
615 589 01 33 00 Puller
Removal & Installation Procedure
1. Put the assembly mark at the crankshaft sprocket (4) and
the timing chain (10) with the paint (arrow).
Installation Notice
Align the assembly marks on cranshaft sprocket and timing
chain. Also, align the assembly marks on camshaft sprocket
and timing chain when installing.
2. Unscrew the bolt (6) and remove the oil pump sprocket (7)
from the oil pump.
Installation Notice
Puller (04) 615 589 01 33 00
3. Remove the oil pump roller chain (9).
4. Remove the oil pump chain tensioner (1), oil pump chain
bushing (2), and the oil pump chain spring (3).
5. Remove the crankshaft sprocket (4) using the puller (04,
special tool).
Notice
l
Make sure not to lose the crankshaft pulley key(5) when
removing.
l
Install the crankshaft sprocket(4) after warming it up.
6. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
29 - 35 Nm
M162 ENGINE MECHANICAL 1B1-85
PISTON
Preceding Work : Removal of engine
Removal of cylinder head
Removal of oil pan
Removal of oil pump
Removal of baffle plate
1 Connecting Rod Bearing Cap
2 Connecting Rod
3 Connecting Rod Bolt (M9 x 52, 12 pieces)
. . . . . . . . . . . . . 1st step 40 Nm
2nd step 90° + 5°
4 Piston
5 Snap Ring
6 Piston Pin
1B1-86 M162 ENGINE MECHANICAL
Tools Required
001 589 72 21 00 Torqued Wrench
000 589 04 14 00 Clamping Strap
Removal Procedure
1. Unscrew the connecting rod bolt (3) and remove the cap.
2. Remove the connecting rod and the piston upward.
Notice
Make sure that the bearing cap and shell are not changed
each other.
3. Remove the snap ring (5) and pull out the piston pin (6).
Notice
Remove the snap ring using a clean cloth as shown in the
right picture so that the piston, piston ring, and the snap
ring don’t get damaged.
Installation Procedure
M162 ENGINE MECHANICAL 1B1-87
1. Check the piston ring gap and apply the engine oil to the
piston pin and the connecting rod bushing.
2. Connect the piston and the connecting rod by pressing in
the piston pin (6) and install the snap ring to the groove.
3. Clean the cylinder bore, connecting rod bearing journal,
connecting rod bearing shell and the piston and coat them
with engine oil.
4. Install the piston ring using the tensioning strap(000 589
04 14 00).
5. Install the piston so that the arrow on the piston head faces
to the forward of the vehicle.
6. After aligning the connecting rod and the bearing cap mark
(// or a number), tighten the bolts.
Installation Notice
Tightening Torque
1st step 35 - 45 Nm
2nd step 90° + 5°
Apply the engine oil to the bearing cap upper and lower
bearing shells.
7. Check if the crankshaft rotates without any trouble by rotating
it.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст