Daewoo Musso. Manual — part 241
4F-26 ANTILOCK BRAKE SYSTEM
Pressure Maintained (Hold)
1 Master Cylinder
2 Hydraulic Unit
3 Damping Chamber
4 Return Pump
5 Return Pump Motor
6 Accumulator Chamber
7 Inlet Valve for Each Wheel
8 Outlet Valve for Each Wheel
9 Wheel
10 Prime Valve (ASV)
11 Pilot Valve (USV)
12 Check Valve
13 ISD (Integrated Suction Damper)
SECTION 4G
PARKING BRAKE
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 4G-1
General Specifications . . . . . . . . . . . . . . . . . . 4G-1
Fastener Tightening Specifications . . . . . . . . . 4G-1
Component Locator . . . . . . . . . . . . . . . . . . . 4G-2
TABLE OF CONTENTS
Parking Brake . . . . . . . . . . . . . . . . . . . . . . . . . 4G-2
Maintenance and Repair . . . . . . . . . . . . . . . 4G-3
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 4G-3
Parking Brake . . . . . . . . . . . . . . . . . . . . . . . . . 4G-3
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this
cable will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK
unless otherwise noted.
SPECIFICATIONS
GENERAL SPECIFICATIONS
Application
Parking Brake Lever Bolt
Cable Mounting Bracket Bolt
N
·
·
·
·
·
m
8 - 18
8 - 18
FASTENER TIGHTENING SPECIFICATIONS
Application
Type
Operating Type
Description
Mechanically Operated Rear Wheel Expansion
Manual
4G-2 PARKING BRAKE
COMPONENT LOCATOR
PARKING BRAKE
1 Parking Brake Lever
2 Praking Brake Lamp Switch
3 Bolt
4 Bolt . . . . . . . . . . . . . . 8-18 Nm
5 Front Parking Brake Cable
6 Equalizer
7 Nut
8 Bolt . . . . . . . . . . . . . . 8-18 Nm
9 Rear Parking Brake Cable
10 Brake Drum (if Equipped with Rear Drum Brake)
11 Brake Disc (if Equipped with Rear Disc Brake)
PARKING BRAKE 4G-3
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
PARKING BRAKE
Removal & Installation Procedure
1. Disconnect the parking brake indicator switch connector.
2. Disconnect the right and left cable from equalizer while
parking brake lever is released.
3. Unscrew 8 bolts and remove the parking brake lever
assembly.
Installation Notice
Notice
Tighten the bolts with sequence number while the lever is
pulled up 4 to 6 notches.
Tightening Torque
8 - 18 Nm
4. Unscrew the frame and lower arm side cable mounting
bracket bolts.
Installation Notice
Tightening Torque
8 - 18 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст