Daewoo Musso. Manual — part 354
SECTION 9R
BODY FRONT END
TABLE OF CONTENTS
Maintenance and Repair . . . . . . . . . . . . . . . 9R-2
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9R-2
Hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9R-2
Fender . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9R-5
![](/vehicles/epme/qux/oho/wisea.png)
9R-2 BODY FRONT END
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
HOOD
1 Hood
2 Sping
3 Hood Hinge Assembly
4 Bolt
![](/vehicles/epme/qux/oho/mandaw.png)
BODY FRONT END 9R-3
Removal & Installation Procedure
1. Remove the hood striker assembly.
Notice
When installing, tighten the bolt after setting the hole
between wratch and hood striker assembly.
Installation Notice
Tightening Toque
8 - 11 Nm
2. Remove the hood Mounting bolt and hood lifter assembly.
Installation Notice
3. Remove the hood lock, hood relese from the clip.
4. Remove the cable holder screw.
5. Pull the cable nut toward driver side.
6. Installation should follow the removal procedure in the
reverse order.
Tightening Toque
14 - 26 Nm
![](/vehicles/epme/qux/oho/yomeroturtin.png)
9R-4 BODY FRONT END
Adjustment Procedure
1. Alignment between hood striker and latch hole.
l
Loosen the mounting bolt of hood latch slightly and adjust
hood in forward/rearward and left/right directions. Then
align the center between hood striker and latch hole.
Notice
Tighten the bolt fully after alignment.
Installation Notice
Tightening Toque
13 - 26 Nm
2. Adjusting the height of hood overslam bumper.
Unlock the hood and check the clearance between hood
and fender by adjusting the hood overslam bumper in left/
right directions.
Normal
20 - 22 Nm
3. Hood Hinge.
l
Loosen the hood lock bolts.
l
Adjust the lock in forward/rearward and left/right
directions, align with the hood striker and adjust the hood
height.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст