Daewoo Musso. Manual — part 230
4A-14 HYDRAULIC BRAKES
LCRV SETTING METHOD
1. LCRV setting should be performed with unladen vehicle
condition.
2. Install the connecting rod (a) to the No.1 hole.
Tightening Torque
14 - 18 Nm
3. Adjust the clearance “X” to be 0 mm and tighten the bolt (c)
using the lock nut (b).
Tightening Torque
14 - 18 Nm
4. Remove the connecting rod (a) from the No.1 hole and
reinstall it to the No. 2 hole.
5. Place alignment marks between the lock nut (b) and
adjusting screw (c) after the valve setting.
SECTION 4B
MASTER CYLINDER
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 4B-1
Fastener Tightening Specifications . . . . . . . . . 4B-1
Maintenance and Repair . . . . . . . . . . . . . . . 4B-2
TABLE OF CONTENTS
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Application
Master Cylinder Nut
Booster Nut
N
·
·
·
·
·
m
14 - 22
8 - 18
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 4B-2
Booster & Brake Master Cylinder . . . . . . . . . . 4B-2
4B-2 MASTER CYLINDER
1 Nut . . . . . . . . . . . . . ... 14-22 Nm
2 Washer
3 Master Cylinder Assembly
4 Oil Level Sensor
5 Check Valve
6 Booster
7 Clevis Pin
8 Snap Pin
9 Seal
10 Spacer
11 Nut . . . . . . . . . . . . . . . 8-18 Nm
12 Front Tube (LH)
13 Front Tube (RH)
14 Rear Tube
15 1st Tube (Primary)
16 2nd Tube (Secondary)
MANDO
PBR
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
BOOSTER AND BRAKE MASTER CYLINDER
MASTER CYLINDER 4B-3
Removal & Installation Procedure
1. Remove the oil level sensor connector.
2. Remove the tube from the master cylinder.
Installation Notice
Notice
l
Be careful not to drop the oil when removing the tube.
l
If the oil is dropped, promptly sweep up.
3. Remove the booster vacuum hose.
Notice
l
Connect fully to the end of vacuum hose when installing.
4. Loosen the nut of master cylinder.
Installation Notice
5. Remove the clevis pin and disconnect the pedal and brake
booster push rod.
Notice
l
Install in the upper hole when PBR brake.
l
Connect the snap pin in the hole of clevis pin fully.
l
Apply the grease around the hole of clevis pin.
Tightening Torque
14 - 22 Nm
Tightening Torque
15 - 19 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст