Daewoo Musso. Manual — part 112
![](/vehicles/epme/qux/oho/ubhy.png)
OM600 ENGINE MECHANICAL 1B3-155
In this position, the marking on the camshaft / camshaft
bearing cap (arrow) must also be aligned.
5. Install the guide pulley (12).
Tightening Torque
23 Nm
6. Attach the tensioning lever (7) to the spring (15) and install.
7. Replace the gasket and install the cylinder head cover.
Tightening Torque
10 Nm
![](/vehicles/epme/qux/oho/arerosnorose.png)
1B3-156 OM600 ENGINE MECHANICAL
TIMING CASE COVER GUIDE RAIL
Preceding Work : Removal of cylinder head cover
1 Bearing Pin
2 Bearing Pin
3 Guide Rail
4 Oil Pump Chain
5 Crankshaft
6 Spring
7 Bushing
8 Tensioning Lever
![](/vehicles/epme/qux/oho/wech.png)
OM600 ENGINE MECHANICAL 1B3-157
Removal Procedure
1. Pull out the tensioning lever (8) together with the spring (6)
and guide rail (3) far enough until the tensioning lever has
moved passed the oil pump chain (4) and is resting against
the crankshaft (5)
2. Pull the tensioning lever (8) off the bearing pin (2) and
carefully remove the spring (6). Remove the tensioning lever
(8) together with the spring (6) and bushing (7).
3. Remove the guide rail (3).
Installation Procedure
1. Install the guide rail (3). Attach the spring (6) to the guide
rail and to the tensioning lever (8).
Notice
Ensure that the spring is correctly located in the guide rail
(arrow).
2. Push the guide rail, spring, bushing and tensioning lever
together onto the bearing pin (1, 2).
![](/vehicles/epme/qux/oho/umowa.png)
1B3-158 OM600 ENGINE MECHANICAL
CRANKSHAFT SPROCKET
Preceding Work : Removal of oil pan
Removal of timing case cover
1 12-Sided Stretch Bolt (M11) .. Check, 25Nm + 90°
2 Washer
3 Camshaft Sprocket
4 Timing Chain
5 Bearing Pin
6 Bearing Pin
7 Oil Pump
8 Oil Pump Sprocket
9 Oil Pump Chain
10 Washer
11 Bolt . . . . . . . . . . . . . . . 25Nm
12 Crankshaft Sprocket
13 Crankshaft
15 Key
16 Guide Rail
17 Spring
18 Bushing
19 Tensioning Lever
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст