Daewoo Musso. Manual — part 176
1F2-64 M161 ENGINE CONTROLS
1 Purge Switchover Valve
2 Molded Hose
3 Fuel Tube (270 mm)
4 Clamp
5 Molded Hose
6 Intake Manifold
7 Throttle Body
VACUUM SYSTEM
Manual Transmission
8 Fuel Pressure Regulator
9 Vacuum Line Rubber Hose (40 mm)
10 Vacuum Tube (Gray, 540 mm)
11 Rubber Cap
12 Molded Hose
13 Vacuum Tube (Brown)
14 Connector
M161 ENGINE CONTROLS 1F2-65
15 Manual Transmission
16 Distributor
Automatic Transmission
A. To Canister
B. To Auto Locking Hub
1F2-66 M161 ENGINE CONTROLS
1 Crankshaft Position Sensor (connector)
2 Bolt (M6 X 14) . . . . . . . . . . 9-11 Nm
CRANKSHAFT POSITION SENSOR
Removal & Installation Procedure
1. Disconnect the wiring connector at the crankshaft position
sensor.
2. Unscrew the bolt (2) and remove the crankshaft position
sensor unit (3).
Installation Notice
3. Installation should follow the removal procedure in the
reverse order.
3 Sensor Unit
Tightening Torque
9 - 11 Nm
M161 ENGINE CONTROLS 1F2-67
Crankshaft Position Sensor Resistance
Inspection
1. Disconnect the coupling "E" of ECU while the ignition switch
is in "OFF" position.
2. Measure the resistance between the coupling terminal pin
No.99 and No.100 using a multimeter.
Notice
Measure the insulator resistance of the crankshaft position
sensor if out of the specified value.
Crankshaft Position Sensor Output Wave
Inspection
1. Connect the test box to the ECU.
2. Measure the output wave between the ECU terminals No.99
and No.100 using the scanner or the oscilloscope while
engine cranking (starter motor activated).
Notice
Check the segment or crankshaft position sensor and air
gap if cannot get the output wave as shown in the figure.
Specified Value
1050 - 1400
W
Specified Value
> 20k
W
Crankshaft Position Sensor Insulator Resistance
Inspection
1. Disconnect the engine coupling from ECU while the ignition
switch is in "OFF" position.
2. Measure the resistance between the coupling terminal pin
No.100 and No.69.
Notice
Measure the check and ground terminal of the crankshaft
position sensor if out of the specified value.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст