Daewoo Matiz (2003 year). Manual — part 293
9T – 28 IMMOBILIZER ANTI-THEFT SYSTEM
DAEWOO M–150 BL2
D29T002
Installation Procedure
1. Install the detection coil by pressing it onto the lock
cylinder until it snaps in place.
2. Connect the two-pin connector to the immobilizer.
D105A505
3. Install the steering column covers with the screws.
Refer to Section 6E, Steering Wheel and Column.
D105A504
IMMOBILIZER CONTROL UNIT
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the steering column covers. Refer to Section
6E, Steering Wheel and Column.
D29T003
3. Slide the immobilizer control unit toward steering
wheel until it slides off its mounting bracket.
4. Disconnect the electrical connectors from the immo-
bilizer control unit (1).
IMMOBILIZER ANTI-THEFT SYSTEM 9T – 29
DAEWOO M–150 BL2
D29T004
Installation Procedure
After replacing the immobilizer control unit, the keys
must be re-authorized using the key coding procedure.
Refer to “Key Coding Procedure” in this section. Also,
the electronic control module (ECM) identification (ID)
code must be reset. Refer to “Identification (ID) Code
Reprogramming” in this section.
1. Connect the electrical connectors to the immobilizer
control unit.
2. Slide the immobilizer control unit onto its mounting
bracket.
D105A505
3. Install the steering column covers. Refer to Section
6E, Steering Wheel and Column.
4. Connect the negative battery cable.
9T – 30 IMMOBILIZER ANTI-THEFT SYSTEM
DAEWOO M–150 BL2
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ
Application
ÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑ
N
S
m
ÑÑÑÑÑÑ
ÑÑÑÑÑÑ
Lb-Ft
ÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑ
Lb-In
Immobilizer Control Unit Mounting Bolts
4
–
35
IMMOBILIZER ANTI-THEFT SYSTEM 9T – 31
DAEWOO M–150 BL2
SCHEMATIC AND ROUTING DIAGRAMS
D19T001B
IM
M
O
BI
L
IZ
E
R ANT
I-
T
H
EF
T
SYST
EM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст