Hyundai Elantra HD: Body Repair Manual — part 3
BODY CONSTRUCTION
BC-5
P - P
Q - Q
R - R
BHDBC6216
R
BHDBC6215
BHDBC6214
P
Q
3.5 mm
12 mm
11 m
m
Rear door panel assembly
Quarter
panel
Fender panel
Hood panel
assembly
Trunk panel assembly
Quarter panel
2.7 mm
3 mm
12.4 mm
BODY
DIMENSIONS
GI
BC
BD
BP
BS
CP
BT
PP
BD-2
BODY DIMENSIONS
GENERAL
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
is no elongation, twisting or bending.
3.
For measuring dimensions, both projected dimension
and actual-measurement dimension are used in this
manual.
MEASUREMENT METHOD
PROJECTED DIMENSIONS
1.
These are the dimensions measured when the
measurement points are projected into the reference
plane, and are the reference dimensions used for body
alterations.
2.
If the length of the tracking gauge probes are
adjustable, make the measurement by lengthening one
probe by the amount equivalent to the difference in
height of the two surfaces.
BMCBD6001
Projected Dimension
Height
BODY DIMENSIONS
BD-3
ACTUAL-MEASUREMENT DIMENSIONS
1.
These dimensions indicate the actual linear distance
between measurement points, and are the reference
dimensions for use if a tracking gauge is used for
measurement.
2.
Measure by first adjusting both probes to the same
length (A=A')
CAUTION
Check the probes and gauge itself to make sure
there is no free play.
MEASUREMENT POINT
1.
Measurements should be taken at the hole center.
BMCBD6003
Hole Center
BMCBD6002
Actually-Measured Dimension
A
A'
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст