Hyundai Santa Fe (2006 year). Manual — part 206
IMMOBILIZER CONTROL SYSTEM
BE -285
COMPONENT INSPECTION
EFD3336B
1.
Check transponder and ECU status
1)
IGN "ON" & Engine "OFF"
2)
Connect scantool to Data Link Connector(DLC).
3)
Erase the DTC and Monitor the "ECU STATUS’ Parameter on the Scantool.
1.1 CURRENT DATA
FIX
SCRN FULL
PART GRPH HELP
01. NO. OF LEARNT KEY
02. ECU STATUS
03. KEY STATUS
Fig 1
Fig 1) The current data in abnormal state
1
LEARNT
LEARNT
SCMBE6752L
4)
Is "ECU STATUS’ Parameter "Locked"?
YES
Keep "KEY ON" status for 1 hours to withdraw "Locked by Timer" status. Then register transponder and go to
"Verification of Vehicle Repair" procedure.
NO
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
VERIFICATION OF VEHICLE REPAIR
EC28D3B9
Refer to DTC P1610.
BE -286
BODY ELECTRICAL SYSTEM
IMMOBILIZER CONTROL UNIT
REPLACEMENT
E2DD9004
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel(A) after re-
moving side cover. (Refer to the Body group - "Crash
pad").
[LHD]
A
SCMBE6580D
[RHD]
A
SCMBE6580R
3.
Disconnect the 5P connector of the SMARTRA unit
and then remove the SMARTRA unit (A) after loosen-
ing a nut.
A
SCMBE6581D
4.
Installation is the reverse of removal procedure.
IMMOBILIZER CONTROL SYSTEM
BE -287
COIL ANTENNA
REPLACEMENT
E0B66B6D
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel (A). (Refer
to the Body group - "Crash pad").
[LHD]
A
SCMBE6590D
[RHD]
A
SCMBE6590R
3.
Disconnect the 6P connector of the coil antenna and
then remove the coil antenna (A) after loosening the
screw.
A
SCMBE6591D
4.
Installation is the reverse of removal procedure.
BE -288
BODY ELECTRICAL SYSTEM
IGNITION SYSTEM
REPLACEMENT
EE8BA5DF
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (Refer to the Body
group - crash pad).
3.
Remove the ignition switch (A) after loosening the
screw with IG ON and disconnecting the 6P connec-
tor.
A
ATLG781A
4.
Remove the steering column cover (Refer to the ST
group).
5.
Remove the door warning switch and key illumination
lamp (A) after disconnecting the 6P connector.
A
SCMBE6531D
6.
If it is necessary to remove the key lock cylinder (A),
Remove the key lock cylinder (A) after pushing lock
pin (B) with key ACC.
A
B
ATIE781C
7.
Installation is the reverse of removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст