Hyundai Santa Fe (2006 year). Manual — part 290
Engine Electrical
System
GENERAL
IGNITION SYSTEM
CHARGING SYSTEM
ALTERNATOR
BATTERY
STARTING SYSTEM
STARTER
STARTER RELAY
EEA -2
ENGINE ELECTRICAL SYSTEM
GENERAL
SPECIFICATION
EA14A9D5
IGNITION SYSTEM
Items
Specification
Primary resistance
0.715 ± 0.015
Ignition coil
Secondary resistance
-
NGK
ILFR5B11
Spark plugs
Plugs Gap
1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in)
STARTING SYSTEM
Items
Specification
Rated voltage
12 V, 1.2 kW
No. of pinion teeth
8
Voltage
11 V
Ampere
90A, MAX
Starter
No-load
characteristics
Speed
2,800 rpm, MIN
CHARGING SYSTEM
Items
Specification
Type
Battery voltage sensing
Rate voltage
13.5 V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
Electronic built-in type
Regulator setting voltage
14.2 ~ 14.8 V
Alternator
Temperature compensation
-4 ± 4mV/ C
Type
MF 68AH
Cold cranking amperage [at -18 C(-0.4 F)]
600 A
Reserve capacity
110 min
Battery
Specific gravity [at 20 C(68 F)]
1.280 ± 0.01
NOTE
-
COLD CRANKING AMPERAGE is the amperage
a battery can deliver for 30 seconds and maintain
a terminal voltage of 7.2V or greater at a specified
temperature.
-
RESERVE CAPACITY RATING is amount of time
a battery can deliver 25A and maintain a mini-
mum terminal voltage of 10.5V at 26.7 C(80.1 F).
GENERAL
EEA -3
TROUBLE SHOOTING
EFA63C2C
IGNITION SYSTEM
Symptom
Suspect area
Remedy
Ignition lock switch
Inspect ignition lock switch, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Spark plugs
Inspect spark plugs, or replace as required
Engine will not start
or is hard to start
(Cranks OK)
Ignition wiring disconnected or broken
Repair wiring, or replace as required
Ignition wiring
Repair wiring, or replace as required
Rough idle or stalls
Ignition coil
Inspect ignition coil, or replace as required
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
Engine hesitates/poor
acceleration
Ignition wiring
Repair wiring, or replace as required
Poor mileage
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
CHARGING SYSTEM
Symptom
Suspect area
Remedy
Fuse blown
Check fuses
Light burned out
Replace light
Wiring connection loose
Tighten loose connection
Charging warning
indicator does not light
with ignition switch "ON"
and engine off.
Electronic voltage regulator
Replace voltage regulator
Drive belt loose or worn
Adjust belt tension or replace belt
Battery cable loose, corroded or worn
Inspect cable connection, repair
or replace cable
Electronic voltage regulator or alternator
Replace voltage regulator or alternator
Charging warning
indicator does not go
out with engine running.
(Battery requires frequent
recharging)
Wiring
Repair or replace wiring
Electronic voltage regulator
Replace voltage regulator
Overcharge
Voltage sensing wire
Repair or replace wiring
Drive belt loose or worn
Adjust belt tension or replace belt
Wiring connection loose or short circuit
Inspect wiring connection, repair
or replace wiring
Electronic voltage regulator or alternator
Replace voltage regulator or alternator
Poor grounding
Inspect ground or repair
Discharge
Worn battery
Replace battery
EEA -4
ENGINE ELECTRICAL SYSTEM
STARTING SYSTEM
Symptom
Suspect area
Remedy
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Transaxle range switch (Vehicle with
automatic transaxle only)
Refer to TR group-automatic transaxle
Fuse blown
Replace fuse
Starter motor faulty
Replace
Engine will not crank
Ignition switch faulty
Replace
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Engine cranks slowly
Starter motor faulty
Replace
Starter motor
Replace
Starter keeps running
Ignition switch
Replace
Short in wiring
Repair wiring
Pinion gear teeth broken or starter motor
Replace
Starter spins but
engine will not crank
Ring gear teeth broken
Replace fly wheel or torque converter
SPECIAL SERVICE TOOL
ECC7A874
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373–27000)
EBDD700A
Removal and installation of
alternator pulley
REFERENCE SERVICE TOOLS
Tool (Number and name)
Illustration
Use
MCR-570 KIT
Battery checker
LBLG001A
For testing 12-volt automotive
staring battery and for testing
12-volt charging system.
(Using with Terminal Pinter_182-
003A)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст