Hyundai Santa Fe (2006 year). Manual — part 247
BR -160
BRAKE SYSTEM
MONITOR ACTUATION TEST
ED3E7D6C
1.
Connect scantool to Data Link Connector(DLC)
2.
Ignition "ON"
&
Engine "OFF".
3.
Select the "Actuation Test" mode on the scantool.
4.
Inspect opearating status of inlet valve with Actuation Test.
Specification : It’s normal if operating sound is heard.
Fig 1) Test Condition : Ignition "ON" & Engine "OFF"
Ex) Actuation Test on Front left valve(in)
Fig1
EJBF504L
5.
Does a inlet valve operate normally?
YES
▶
Fault is intermittent caused by inoperative valve or was repaired and HECU memory was not cleared. Go to the
pplicable troubleshooting procedure.
NO
▶
Go to "W/Harness Inspection" procedure.
ABS (ANTI-LOCK BRAKE SYSTEM)
BR -161
TERMINAL AND CONNECTOR INSPECTION
EE3CAC26
1.
Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused
by interference from other electrical systems, and mechanical or chemical damage.
2.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or
damage.
3.
Has a problem been found?
YES
▶
Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
▶
Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and
then go to "Verification of Vehicle Repair" procedure.
VERIFICATION OF VEHICLE REPAIR
E05FDCDF
Refer to DTC C1101.
BR -162
BRAKE SYSTEM
DTC C2312 FL OUTLET VALVE MALFUNCTION
DTC C2320 FR OUTLET VALVE MALFUNCTION
DTC C2328 RL OUTLET VALVE MALFUNCTION
DTC C2336 RR OUTLET VALVE MALFUNCTION
COMPONENT LOCATION
E17CE012
Refer to DTC C1235.
GENERAL DESCRIPTION
E765168C
Refer to DTC C2308.
DTC DESCRIPTION
EB63DB57
Refer to DTC C2308.
DTC DETECTING CONDITION
EF1E4919
Refer to DTC C2308.
ABS (ANTI-LOCK BRAKE SYSTEM)
BR -163
MONITOR ACTUATION TEST
EF9ABF10
1.
Connect scantool to Data Link Connector(DLC)
2.
Ignition "ON"
&
Engine "OFF".
3.
Select the "Actuation Test" mode on the scantool.
4.
Inspect opearating status of outlet valve with Actuation Test.
Specification : It’s normal if operating sound is heard.
Fig 1) Test Condition : Ignition "ON" & Engine "OFF"
Ex) Actuation Test on Front left valve(out)
Fig1
SCMBR6572L
5.
Does a inlet valve operate normally?
YES
▶
Fault is intermittent caused by inoperative valve or was repaired and HECU memory was not cleared. Go to the
pplicable troubleshooting procedure.
NO
▶
Go to "Component Inspection" procedure.
TERMINAL AND CONNECTOR INSPECTION
E3277A22
Refer to DTC C2308.
VERIFICATION OF VEHICLE REPAIR
EF041650
Refer to DTC C1101.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст