Hyundai Elantra Neos / Hyundai i30. Manual — part 36
CP-2
CORROSION PROTECTION
ZINC-PHOSPHATE COAT & CATIONIC ELECTRODEPOSITION PRIMER
In order to improve the adhesion of the paint coat on the steel panel, and also to improve the corrosion resistance, the entire
body is coated with a film of Zinc-phosphate and a cationic electrodeposition primer.
BMCCP6020
Cationic electrodeposition primer
Zinc-phosphate film
Body steel panel
CORROSION PROTECTION
CP-3
1.
Heat the "antivibration pad" with a blow drier to soften
it.
2.
Align the antivibration pad layer in the position where
it is to be installed, and then press it down with a roller
or a block of wood so that it adheres well.
NOTE
An infrared lamp can also be used to heat both the
antivibration pad layer and the body panels(be sure to
wear gloves).
BMCCP6041
BMCCP6042
ATTACHMENT OF ANTIVIBRATION PADS
Antivibration pads are attached to the upper surface of the floor and at the interior side of the dash panel in order to absorb
vibrations and shut out exhaust gas heat. If these antivibration pads are peeled off in the course of replacement or repair of
a welded panel, cut and attach replacement material (in the shape shown in the figure).
BFDCP6201
F
F
84123-1H000
84127-1H000
84125-2L000
84181-1H000
84171-1H000
84115-2L000
84117-1H000
84113-1H000
84193-2L000
CP-4
CORROSION PROTECTION
ANTIVIBRATION PADS-LOCATION & SECTION
F
F
H
H
BEDCP6202
[ 5 Door ]
[Wagon ]
G
G
C
C
D
D
E
E
H
H
A
A
B
B
I
I
84123-1H000
84127-1H000
84125-2L000
84181-1H000
84171-1H000
84115-2L000
84181-2L200
84171-2L200
84193-2L000
84117-1H000
84113-1H000
84193-2L000
CORROSION PROTECTION
CP-5
BFDCP6207
BFDCP6205
BFDCP6206
BFDCP6204
BFDCP6203
B - B
C - C
A - A
D - D
E - E
Dash panel
Dash panel
Center floor panel
Center floor side member
Center floor panel
24mm
25mm
82mm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст