Chrysler Sebring, Stratus sedan, Sebring Convertible. Manual — part 53
Symptom:
POST FAILURE
When Monitored and Set Condition:
POST FAILURE
When Monitored:
At battery connect.
Set Condition:
The BCM fails ROM checksum test.
POSSIBLE CAUSES
POST FAILURE
TEST
ACTION
APPLICABILITY
1
Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC’s.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
197
COMMUNICATION
Symptom:
SKIM MESSAGES NOT RECEIVED
When Monitored and Set Condition:
SKIM MESSAGES NOT RECEIVED
When Monitored:
With the ignition on.
Set Condition:
The BCM does not receive any messages from the Sentry Key Immobilizer
Module (SKIM) for at least 12 seconds.
POSSIBLE CAUSES
ATTEMPT TO COMMUNICATE WITH THE SENTRY KEY IMMOBILIZER MODULE
BODY CONTROL MODULE
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
With the DRB, attempt to communicate with the SKIM.
Was the DRB able to I/D or communicate with the SKIM?
All
Yes
→ Go To 2
No
→ Refer to the Communication category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1.
2
With the DRB, erase DTC’s.
Turn the ignition on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
198
COMMUNICATION
Symptom:
TCM MESSAGES NOT RECEIVED
When Monitored and Set Condition:
TCM MESSAGES NOT RECEIVED
When Monitored:
With the ignition on.
Set Condition:
The BCM does not receive any messages from the Transmission Control
Module (TCM) for at least 18 seconds. Note: If NGC, the TCM is internal to the PCM.
POSSIBLE CAUSES
ATTEMPT TO COMMUNICATE WITH THE TCM
BODY CONTROL MODULE
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
With the DRB, enter Transmission.
Was the DRB able to I/D or communicate with the TCM?
All
Yes
→ Go To 2
No
→ Refer to the Communication category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1.
2
With the DRB, erase DTC’s.
Turn the ignition on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
199
COMMUNICATION
Symptom:
TRAVELER MESSAGES NOT RECEIVED (CMTC)
When Monitored and Set Condition:
TRAVELER MESSAGES NOT RECEIVED (CMTC)
When Monitored:
With the ignition on.
Set Condition:
The BCM does not receive any messages from the Traveler (Compass/Mini
Trip Computer) for at least 14 seconds.
POSSIBLE CAUSES
ATTEMPT TO COMMUNICATE WITH THE TRAVELER (CMTC)
BODY CONTROL MODULE
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
With the DRB, enter Body then Overhead Console.
Was the DRB able to I/D or communicate with the Traveler (CMTC)?
All
Yes
→ Go To 2
No
→ Refer to the Communication category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1.
2
With the DRB, erase DTC’s.
Turn the ignition on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
200
COMMUNICATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст