Chrysler Sebring, Stratus sedan, Sebring Convertible. Manual — part 763
TEST
ACTION
APPLICABILITY
10
The conditions necessary to set the DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring and connectors while checking for shorts and open circuits.
With the DRBIII
t, check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Were there any problems found?
All
Yes
→ Repair as necessary.
Perform 40/41TE (NGC) TRANSMISSION VERIFICATION
TEST - VER 1.
No
→ Test Complete.
24
TRANSMISSION - NGC
P0562-LOW BATTERY VOLTAGE —
Continued
Symptom:
P0602-CONTROL MODULE PROGRAMMING ERROR
When Monitored and Set Condition:
P0602-CONTROL MODULE PROGRAMMING ERROR
When Monitored:
Continuously
Set Condition:
The DTC will always light the MIL, and is designed to signal the
technician that the controller still has generic software installed.
TEST
ACTION
APPLICABILITY
1
NOTE: Controller is programmed with generic software and will not allow
the correct vehicle Powertrain management.
Record the vehicles controller part number.
Select Use Controller Part Number under the Flash Tab.
Flash the controller with the correct software.
Test complete
All
Yes
→ Test Complete.
25
TRANSMISSION - NGC
Symptom List:
P0604-INTERNAL TCM
P0605-INTERNAL TCM
P0613-INTERNAL TCM
Test Note:
All symptoms listed above are diagnosed using the same tests.
The title for the tests will be P0604-INTERNAL TCM.
POSSIBLE CAUSES
PCM - INTERNAL ERROR
TEST
ACTION
APPLICABILITY
1
Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Powertrain Control Module. WITH THE DRBIII
t
PERFORM QUICK LEARN AND REPROGRAM PINION FAC-
TOR.
Perform 40/41TE (NGC) TRANSMISSION VERIFICATION
TEST - VER 1.
26
TRANSMISSION - NGC
Symptom:
P0706-CHECK SHIFTER SIGNAL
When Monitored and Set Condition:
P0706-CHECK SHIFTER SIGNAL
When Monitored:
Continuously with the ignition on.
Set Condition:
After 3 occurrences in one ignition cycle of an invalid PRNDL DTC which
lasts for more than 0.1 second. Note: All indicator lights on the instrument cluster will
illuminate boxed when the vehicle engine is not running, ignition on or engine running in
park or neutral if a problem exists.
POSSIBLE CAUSES
SHIFTER OUT OF ADJUSTMENT
TRS T1 SENSE CIRCUIT OPEN
TRS T3 SENSE CIRCUIT OPEN
TRS T41 SENSE CIRCUIT OPEN
TRS T42 SENSE CIRCUIT OPEN
TRS T1 SENSE CIRCUIT SHORT TO GROUND
TRS T3 SENSE CIRCUIT SHORT TO GROUND
TRS T41 SENSE CIRCUIT SHORT TO GROUND
TRS T42 SENSE CIRCUIT SHORT TO GROUND
TRS T1 SENSE CIRCUIT SHORT TO VOLTAGE
TRS T3 SENSE CIRCUIT SHORT TO VOLTAGE
TRS T41 SENSE CIRCUIT SHORT TO VOLTAGE
TRS T42 SENSE CIRCUIT SHORT TO VOLTAGE
TRANSMISSION RANGE SENSOR
POWERTRAIN CONTROL MODULE
INTERMITTENT WIRING AND CONNECTORS
27
TRANSMISSION - NGC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст