Chrysler RG Voyager. Manual — part 83
Symptom:
CD PLAY FAILURE
When Monitored and Set Condition:
CD PLAY FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD or is
scratched, dirty so the radio can not play the CD.
POSSIBLE CAUSES
CD PLAY FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD PLAY FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
301
AUDIO
Symptom:
CD READ FAILURE
When Monitored and Set Condition:
CD READ FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD is installed
in the radio CD player.
POSSIBLE CAUSES
CD READ FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD READ FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
302
AUDIO
Symptom:
CD TEMPERATURE HIGH
When Monitored and Set Condition:
CD TEMPERATURE HIGH
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if the temperature inside the radio CD player is above
+85° C (+185° F).
POSSIBLE CAUSES
HIGH TEMPERATURE FAILURE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase the audio DTC’s.
Start the engine and allow the engine to reach normal operating temperature.
If the vehicle has been in the hot sunlight or extreme cold move the vehicle indoors
and open the doors to allow the inside temperature to stabilize.
The radio CD player will operate between -30° C and 85° C (-22° F and +185° F).
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD TEMPERATURE HIGH?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
303
AUDIO
Symptom:
GPS ANTENNA NOT CONNECTED
When Monitored and Set Condition:
GPS ANTENNA NOT CONNECTED
When Monitored:
With the ignition on and the radio in navigation mode.
Set Condition:
The radio does not detect a GPS antenna connection.
POSSIBLE CAUSES
BAD ANTENNA CONNECTION
ANTENNA
RADIO
TEST
ACTION
APPLICABILITY
1
Turn the ignition off.
Disconnect the GPS Antenna connector.
Inspect the GPS Antenna connection.
Was the Antenna connection clean and tight?
All
Yes
→ Go To 2
No
→ Repair Antenna connection as needed.
Perform BODY VERIFICATION TEST - VER 1.
2
Refer to the Audio System in the service information and test the Antenna in
accordance with the service procedure.
Is the Antenna ok?
All
Yes
→ Go To 3
No
→ Repair or replace the Antenna assembly as necessary.
Perform BODY VERIFICATION TEST - VER 1.
3
NOTE: Reconnect all previously disconnected components.
NOTE: Move vehicle outside approximately 30ft from any structure.
Turn the ignition and Radio on.
With the DRBIII
t, erase the audio DTC’s and operate the navigation system.
With the DRBIII
t, read the audio DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Radio in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
304
AUDIO
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст