Chrysler Le Baron, Dodge Dynasty, Plymouth Acclaim. Manual — part 567
CAUTION: Be sure that the tapped holes maintain
the original centerline.
Heli-Coil tools and inserts are readily available
from automotive parts jobbers.
HYDROSTATIC LOCKED ENGINE
When an engine is suspected to be hydrostaticly
locked, regardless of what caused the problem, these
steps should be used.
CAUTION: Do Not Use Starter Motor To Rotate En-
gine, severe damage may occur.
(1) Inspect air cleaner, induction system and in-
take manifold to insure system is dry and clear of
foreign material.
(2) Remove negative battery cable.
(3) Place a shop towel around the spark plugs
when removing them from the engine. This will
catch any fluid that may possibly be in the cylinder
under pressure.
(4) With all spark plugs removed, rotate engine
crankshaft using a breaker bar and socket.
(5) Identify the fluid in the cylinder(s) (i.e., cool-
ant, fuel, oil or other).
(6) Make sure all fluid has been removed from the
cylinders. Inspect engine for damage (i.e., Connecting
Rods, Pistons, Valves etc.)
(7) Repair engine or components as necessary to
prevent this problem from occurring again.
CAUTION: Squirt approximately 1 teaspoon of oil
into cylinders, rotate engine to lubricate the cylin-
der walls to prevent damage on restart.
(8) Install new spark plugs.
(9) Drain engine oil and remove oil filter.
(10) Fill engine with specified amount of approved
oil and install new oil filter.
(11) Connect negative battery cable.
(12) Start engine and check for any leaks.
Ä
ENGINE
9 - 5
ENGINE DIAGNOSIS—PERFORMANCE
9 - 6
ENGINE
Ä
ENGINE DIAGNOSIS—MECHANICAL
Ä
ENGINE
9 - 7
2.2/2.5L ENGINES
INDEX
page
page
Balance Shafts
. . . . . . . . . . . . . . . . . . . . . . . . . . 45
Camshaft and Crankshaft Timing Procedure
. . . . 34
Camshaft, Crankshaft and Intermediate Shafts
Timing Procedure
. . . . . . . . . . . . . . . . . . . . . . . 20
Camshafts Service
. . . . . . . . . . . . . . . . . . . . . . . 36
Checking Engine Oil Pressure
. . . . . . . . . . . . . . . 60
Crankshaft Oil Seals Service
. . . . . . . . . . . . . . . . 42
Crankshaft Service
. . . . . . . . . . . . . . . . . . . . . . . 43
Crankshaft, Intermediate and Balance Shaft
Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
Cylinder Block, Piston and Connecting Rod
Assembly Service
. . . . . . . . . . . . . . . . . . . . . . . 49
Cylinder Head
. . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Cylinder Head and Valve Assembly
Service—Except Turbo III
. . . . . . . . . . . . . . . . . 22
Cylinder Head and Valve Assembly
Service—Turbo III
. . . . . . . . . . . . . . . . . . . . . . 31
Cylinder Head Components—In-Vehicle Service
. 23
Engine Assembly
. . . . . . . . . . . . . . . . . . . . . . . . . 13
Engine Core Plugs
. . . . . . . . . . . . . . . . . . . . . . . 55
Engine Lubrication System
. . . . . . . . . . . . . . . . . 56
Engine Mounts
. . . . . . . . . . . . . . . . . . . . . . . . . . 12
Engine Specifications
. . . . . . . . . . . . . . . . . . . . . . 62
General Information
. . . . . . . . . . . . . . . . . . . . . . . . 8
Intermediate Shaft Service
. . . . . . . . . . . . . . . . . . 47
Lash Adjuster (Tappet) Noise
. . . . . . . . . . . . . . . 37
Oil Filter
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61
Oil Pan
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58
Oil Pump Service
. . . . . . . . . . . . . . . . . . . . . . . . 58
Solid Mount Compressor Bracket Service
. . . . . . 14
Timing System and Seals Service—
Except Turbo III . . . . . . . . . . . . . . . . . . . . . . . .
Valve Components Replace—Cylinder Head
Not Removed
. . . . . . . . . . . . . . . . . . . . . . . . . . 37
Valve Service—Cylinder Head Removed
. . . . . . . 27
Valve Springs and Valve Stem Seals
. . . . . . . . . 38
GENERAL INFORMATION
ENGINE IDENTIFICATION NUMBER OR CODE
The engine identification number is located on the
rear of the cylinder block just below the cylinder
head (Fig. 1).
METHANOL FUEL COMPATIBILITY IDEN-
TIFICATION
Beginning this model year, Chrysler began produc-
ing AA-Body vehicles designed to operate on a mix-
ture of gasoline and methanol. These automobiles are
referred to as Flexible Fuel vehicles.
2.2/2.5L ENGINE SPECIFICATION
9 - 8
2.2/2.5L ENGINE
Ä
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст