Chrysler Pacifica. Manual — part 74
Symptom:
CD PLAY FAILURE
When Monitored and Set Condition:
CD PLAY FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD or is
scratched, dirty so the radio can not play the CD.
POSSIBLE CAUSES
CD PLAY FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD PLAY FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
293
AUDIO
Symptom:
CD READ FAILURE
When Monitored and Set Condition:
CD READ FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD is installed
in the radio CD player.
POSSIBLE CAUSES
CD READ FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD READ FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
294
AUDIO
Symptom:
CD TEMPERATURE HIGH
When Monitored and Set Condition:
CD TEMPERATURE HIGH
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if the temperature inside the radio CD player is above
+85° C (+185° F).
POSSIBLE CAUSES
HIGH TEMPERATURE FAILURE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase the audio DTC’s.
Start the engine and allow the engine to reach normal operating temperature.
If the vehicle has been in the hot sunlight or extreme cold move the vehicle indoors
and open the doors to allow the inside temperature to stabilize.
The radio CD player will operate between -30° C and 85° C (-22° F and +185° F).
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD TEMPERATURE HIGH?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
295
AUDIO
Symptom:
EQ FAULT - NO EQ ACTIVE - AMPLIFIER
When Monitored and Set Condition:
EQ FAULT - NO EQ ACTIVE - AMPLIFIER
When Monitored:
When the DRBIII
t performs the Identify EQ Test.
Set Condition:
When the Amplifier detects a fault with the current EQ mode.
POSSIBLE CAUSES
AMPLIFIER
INTERMITTENT CONDITION
TEST
ACTION
APPLICABILITY
1
NOTE: The fault condition must be present to continue diagnosis. Use the
DRBIII
t to perform the Amplifier pretest to verify the fault condition is
present before continuing diagnosis.
Turn the ignition on.
With the DRBIII
t, perform the Amplifier pretest.
Is the fault condition present?
All
Yes
→ Replace the Amplifier in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to the wiring diagrams in the service information to help
isolate a possible intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
296
AUDIO
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст