Chrysler Pacifica. Manual — part 794
(14) Remove regulator valve spring retainer (Fig.
415).
(15) Remove remaining retainers as shown in (Fig.
416).
Fig. 415 Remove Regulator Valve Spring Retainer
using Tool 6302
1 - TOOL 6302
2 - RETAINER
Fig. 416 Valve Retainer Location
1 - RETAINER
2 - RETAINER
CS
41AE/TE AUTOMATIC TRANSAXLE
21 - 171
VALVE BODY (Continued)
(16) Remove valves and springs as shown in (Fig.
417).
NOTE: Refer to Valve Body Cleaning and Inspection
for cleaning procedures.
ASSEMBLY
NOTE: If valve body assembly is reconditioned, the
PCM/TCM Quick Learn Procedure must be per-
formed. (Refer to 8 - ELECTRICAL/ELECTRONIC
CONTROL
MODULES/TRANSMISSION
CONTROL
MODULE - STANDARD PROCEDURE)
(1) Install valves and springs as shown in (Fig.
417).
(2) Install regulator valve spring retainer (Fig.
418).
Fig. 417 Springs and Valves Location
1 - VALVE BODY
5 - MANUAL VALVE
2 - T/C REGULATOR VALVE
6 - CONVERTER CLUTCH SWITCH VALVE
3 - L/R SWITCH VALVE
7 - SOLENOID SWITCH VALVE
4 - CONVERTER CLUTCH CONTROL VALVE
8 - REGULATOR VALVE
Fig. 418 Install Regulator Valve Spring Retainer
using Tool 6302
1 - TOOL 6302
2 - RETAINER
21 - 172
41AE/TE AUTOMATIC TRANSAXLE
CS
VALVE BODY (Continued)
(3) Install dual retainer plate using Tool 6301 (Fig.
419).
(4) Verify that all retainers are installed as shown
in (Fig. 420). Retainers should be flush or below
valve body surface.
Fig. 419 Install Dual Retainer Plate using Tool 6301
1 - TOOL 6301
2 - RETAINER
Fig. 420 Valve Retainer Location
1 - RETAINER
2 - RETAINER
CS
41AE/TE AUTOMATIC TRANSAXLE
21 - 173
VALVE BODY (Continued)
(5) Install check balls into position as shown in
(Fig. 421). If necessary, secure them with petrolatum
or transmission assembly gel for assembly ease.
(6) Install thermal valve into transfer plate (Fig.
422).
(7) Install separator plate to valve body (Fig. 423).
(8) Install the overdrive clutch (#5) check valve to
separator plate (Fig. 424)
(9) Install oil screen to separator plate (Fig. 425).
(10) Install transfer plate to valve body and sepa-
rator plate. Make sure oil screen and #5 check valve
do not bind (Fig. 426).
Fig. 421 Ball Check Location
1 - (#4) BALL CHECK LOCATION
2 - (#2) BALL CHECK LOCATION
3 - RETAINER
4 - (#3) BALL CHECK LOCATION
5 - LOW/REVERSE SWITCH VALVE
6 - T/C LIMIT VALVE
Fig. 422 Install Thermal Valve
1 - THERMAL VALVE
21 - 174
41AE/TE AUTOMATIC TRANSAXLE
CS
VALVE BODY (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст