Chrysler Pacifica. Manual — part 488
(6) Remove cover from battery cable on rear of
generator (Fig. 11).
(7) Remove the positive battery cable from rear of
generator.
(8) Remove the accessory drive belt (Fig. 12), refer
to (Refer to 7 - COOLING/ACCESSORY DRIVE/
DRIVE BELTS - REMOVAL).
(9) Remove the 3 mounting bolts for the power
steering assembly (Fig. 13).
(10) Relocate the power steering assembly (Fig.
14).
Fig. 11 GENERATOR BATTERY CONNECTION
COVER
Fig. 12 DRIVE BELT REMOVED
Fig. 13 POWER STEERING PUMP MOUNTING
BOLTS
Fig. 14 POWER STEERING PUMP RELOCATION
CS
CHARGING
8F - 21
GENERATOR (Continued)
(11) Remove the idler pulley/lower mounting bolt
for generator (Fig. 15). This will be removed with
generator assembly.
(12) Remove the rear mounting bolt (Fig. 16).
(13) Remove the upper mounting bolt (Fig. 17).
(14) Remove generator and idler pulley (Fig. 18).
Fig. 15 IDLER PULLEY
Fig. 16 GENERATOR REAR MOUNTING BOLT
Fig. 17 UPPER MOUNTING BOLT
Fig. 18 GENERATOR REMOVE/INSTALL
8F - 22
CHARGING
CS
GENERATOR (Continued)
INSTALLATION
3.5L
(1) Install generator.
(2) Install the 2 lower mounting bolts (Fig. 19).
(3) Install the upper mounting bracket (Fig. 20).
(4) Tighten the 2 lower bolts first, tighten bolts to
54.2 N·m (40 ft. lbs.) then tighten the 2 upper bolts,
tighten bolts to 28.2 N·m (20.8 ft. lbs.)
(5) Connect the generator field circuit wiring con-
nector (Fig. 21). Push the RED locking tab to lock
connector.
(6) Install the B+ terminal nut and wire making
sure the terminal is properly oriented with the anti-
rotation tab (Fig. 5).
(7) Tighten nut to 12.5 N·m (110 in. lbs.).
(8) Install the generator drive belt, refer to (Refer
to
7
-
COOLING/ACCESSORY
DRIVE/DRIVE
BELTS - INSTALLATION).
(9) Install the engine cover.
(10) Connect battery negative cable.
3.8L
(1) Install idler pulley to generator (Fig. 22).
(2) Install assembly to vehicle.
Fig. 19 GENERATOR
Fig. 20 UPPER MOUNTING BRACKET
Fig. 21 POSITIVE BATTERY CABLE & FIELD
CONNECTOR
Fig. 22 GENERATOR REMOVE/INSTALL
CS
CHARGING
8F - 23
GENERATOR (Continued)
(3) Loose install upper mounting bolt (Fig. 23).
(4) Loose install rear mounting bolt (Fig. 24).
(5) Loose install the lower mounting bolt (Fig. 25).
(6) Idler pulley installed (Fig. 26).
(7) Tighten bolts to 54.2 N·m (40 ft. lbs.).
Fig. 23 UPPER MOUNTING BOLT
Fig. 24 GENERATOR REAR MOUNTING BOLT
Fig. 25 IDLER PULLEY
Fig. 26 IDLER PULLEY INSTALLED
8F - 24
CHARGING
CS
GENERATOR (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст