Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1765
MODULE-FUEL PUMP
REMOVAL
1. Release the fuel pressure, refer to the Fuel Pressure Release Procedure in this section.
2. Disconnect negative battery cable.
NOTE: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings.
If it is above that you can spill fuel in the vehicle.
3. Drain partial fuel from fuel tank through the filler
tube. Use a hard nylon tube, with a 30° cut on the
end, to push the check valve open to drain fuel
from tank.
4. Remove the rear lower seat cushion.
14 - 134
FUEL DELIVERY - DIESEL
LX
5. Push seat back and up to remove seat cushion.
6. Fold back the foam pad covering access cover for
modules.
LX
FUEL DELIVERY - DIESEL
14 - 135
7. Disconnect the electrical connector from left side
module.
8. Mark the module orientation.
9. Use special tool #9340 to remove left side module
lock ring.
10. Drain fuel from left side of fuel tank. Lift module
up enough to push hose into tank and drain. Do
not spill fuel in interior of vehicle.
14 - 136
FUEL DELIVERY - DIESEL
LX
11. Disconnect the electrical connectors from the
module top.
12. Remove the module top half.
13. The module fuel level sending card (1). The fuel
return lines (2). The fuel supply line (3).
14. Fuel line release tab, press in the tab and pull up
on fuel line.
LX
FUEL DELIVERY - DIESEL
14 - 137
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст