Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 225
C2204-DYNAMICS SENSOR INTERNAL
For a complete wiring diagram Refer to Section 8W.
5 - 342
BRAKES - ABS ELECTRICAL DIAGNOSTICS
LX
•
When Monitored:
Continuously, with ignition on, until vehicle speed exceeds 20 km/h (12.4 m.p.h.) for the first time, but not if the
sensor voltage is out of range.
Or, during diagnostic mode.
Or, if the monitoring was inhibited by a corresponding diagnostics command.
Or, if the vehicle speed has exceeded 20 km/h (12.4 m.p.h.) during the actual ignition cycle.
Or, if at least one over spinning wheel is detected.
Or, if one of the control functions is active.
•
Set Condition:
If the Anti-Lock Brakes Module detects that the Lateral Sensor signal is out of range.
Possible Causes
DYNAMICS SENSOR INSTALLATION
DYNAMICS SENSOR
ANTI-LOCK BRAKES MODULE
Diagnostic Test
1.
VERIFY DTC IS ACTIVE
Turn the ignition on.
With the scan tool, read and record ABS DTCs.
With the scan tool, read and record Environmental Data (EV Data).
With the scan tool, erase ABS DTCs.
Cycle the ignition switch.
WARNING: Ensure brake capability is available before road testing.
Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 20 km/hr
(6 and 12 m.p.h.).
Park the vehicle.
With the scan tool, read ABS DTCs.
Does this DTC reset?
Yes
>> Go To 2
No
>> Perform the ABS Intermittent Condition diagnostic procedure in this Section.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
2.
CHECK THE DYNAMICS SENSOR INSTALLATION
NOTE: Dynamics Sensor installation and mounting bolt torque is crucial for proper operation.
Turn the ignition off.
Check the Dynamics Sensor for damaged, modified, and bent mounting brackets.
Check the Dynamics Sensor mounting bolts for a loose or over tightened condition.
Were any problems found?
Yes
>> Repair as necessary.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
No
>> Go To 3
LX
BRAKES - ABS ELECTRICAL DIAGNOSTICS
5 - 343
3.
CHECK DYNAMICS SENSOR OUTPUT
CAUTION: All previously removed connectors must be connected before test driving the vehicle.
Connect all previously disconnected components and connectors.
WARNING: Ensure brake capability is available before road testing.
Monitor Dynamics Sensor operation while an assistant drives the vehicle.
Is Lateral Sensor output between 0.02 G to 0.16 G and Yaw Sensor output between 1.30° to 5.70°
Yes
>> Replace the Anti-Lock Brakes Module in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
No
>> Replace the Dynamics Sensor in accordance with the Service Information.
Perform ABS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES - STANDARD PROCEDURE).
5 - 344
BRAKES - ABS ELECTRICAL DIAGNOSTICS
LX
C2205-STEERING ANGLE SENSOR INTERNAL
For a complete wiring diagram Refer to Section 8W.
LX
BRAKES - ABS ELECTRICAL DIAGNOSTICS
5 - 345
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст