Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 143
SPECIAL TOOLS
BASE BRAKE SYSTEM
Adapter, Master Cylinder Pressure Bleed Cap 6921
Tubes, Master Cylinder Bleed 8358
Adapters, Master Cylinder 8822
Installer, Dust Boot 9314
Installer, Dust Boot 9315
Adapters, Master Cylinder 9748
Dial Indicator C-3339A
Handle, Universal C–4171
5 - 14
BRAKES - BASE
LX
SWITCH-ADJUSTABLE PEDALS
DESCRIPTION
The adjustable pedals switch is located on the left
side trim of the driver’s seat cushion. Fore and Aft
movement of the paddle-type switch allows front-to-
rear travel of the adjustable pedals, up to approxi-
mately 76 mm (3 inches) total movement. Pushing the
paddle forward moves the peddles away from the
driver and vice-versa. Movement stops when the
switch is released.
The switch actuates the electric motor-driven adjust-
able pedals mechanism through the memory seat
module (MSM). MSM logic prevents pedal adjustment
while the speed control is set and when the transmis-
sion is in Reverse.
REMOVAL
1. Move driver’s seat to full-forward, full-upward position.
2. Disconnect battery negative cable from battery post and isolate.
3. Remove seat belt shield from driver’s seat cushion left side trim.
4. Remove three screws fastening seat cushion side trim in place.
5. Lift side trim from seat and utilizing slack in seat belt, turn trim over.
6. Disconnect wiring connector (2) from adjustable
pedals switch (3).
7. Remove two mounting screws (1) and remove
switch (3).
LX
BRAKES - BASE
5 - 15
INSTALLATION
1. Position switch (3) connector-side-down on the
inside of the driver’s seat cushion side trim.
2. Install two screws (1) fastening switch in place.
3. Connect wiring connector (2) to adjustable pedals
switch (3).
4. Position side trim on driver’s seat cushion left side
and install three screws fastening side trim in
place.
5. Install seat belt shield on driver’s seat cushion left
side trim.
6. Connect negative battery cable to battery post.
(Refer to 8 - ELECTRICAL/BATTERY SYSTEM -
STANDARD PROCEDURE)
7. Check operation of adjustable pedals.
8. If vehicle is equipped with memory seats, the sys-
tem will need to be initialized. Refer to appropriate
diagnostic information.
5 - 16
BRAKES - BASE
LX
SENSOR - BRAKE FLUID LEVEL
REMOVAL
The brake fluid level sensor (2) is an integral part of
the master cylinder fluid reservoir (1). (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/FLUID RESER-
VOIR - REMOVAL)
INSTALLATION
The brake fluid level sensor (2) is an integral part of
the master cylinder fluid reservoir (1). (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/FLUID RESER-
VOIR - INSTALLATION)
LX
BRAKES - BASE
5 - 17
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст