Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2186
ASSEMBLY-MODULE
REMOVAL
WARNING: The excessive force limitation (efl) fea-
ture must be calibrated any time a sunroof motor/
module is replaced with a new component. Failure
to perform this procedure could result in vehicle
damage and/or personal injury. (refer to 8 - electri-
cal/power top/motor - standard procedure - exces-
sive
force
limitation
(efl)
calibration)
for
the
appropriate procedure.
1. Move glass panel to the fully closed position.
2. Disconnect and isolate the battery negative cable.
3. Remove headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - REMOVAL).
4. Disconnect the sunroof wire harness electrical
connector.
5. Disconnect the four drain tubes (1) from sunroof
housing.
23 - 292
SUNROOF - SERVICE INFORMATION
LX
6. Remove the eight fasteners (3) attaching sunroof assembly.
7. With the aid of a helper, support the sunroof and remove the fasteners (2) attaching sunroof assembly (1) to roof
panel.
8. Remove the sunroof (1) from vehicle.
LX
SUNROOF - SERVICE INFORMATION
23 - 293
INSTALLATION
WARNING: The excessive force limitation (efl) feature must be calibrated any time a sunroof motor/module
is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or
personal injury. (refer to 8 - electrical/power top/motor - standard procedure - excessive force limitation (efl)
calibration) for the appropriate procedure.
1. Verify that glass panel is loose and slightly retracted.
2. Raise sunroof module assembly (1) and guide it carefully into position.
23 - 294
SUNROOF - SERVICE INFORMATION
LX
3. While supporting the sunroof assembly start the 12 attaching screws and tighten the attaching screws to 6 N·m
(53 in. lbs.) using the sequence shown.
4. Connect the electrical connector.
5. Connect the drain tubes to the sunroof (1).
6. Adjust the sunroof glass. (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - ADJUSTMENTS)
7. Connect battery negative cable.
8. Install the vehicle headliner, (Refer to 23 - BODY/
INTERIOR/HEADLINER - INSTALLATION).
9. Perform the sunroof position calibration, (Refer to 8
- ELECTRICAL/POWER TOP/MOTOR - STAN-
DARD
PROCEDURE
-
SUNROOF
POSITION
CALIBRATION).
10. Perform the Excessive Force Limitation (EFL) cal-
ibration, (Refer to 8 - ELECTRICAL/POWER TOP/
MOTOR
-
STANDARD
PROCEDURE
-
EXCESSIVE FORCE LIMITATION (EFL) CALI-
BRATION).
11. Verify proper operation of the power sunroof
system.
LX
SUNROOF - SERVICE INFORMATION
23 - 295
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст