Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1559
INSTALLATION
UPPER INTAKE MANIFOLD
1. Clean and inspect gasket sealing surfaces.
2. Position new gasket.
3. Install the upper intake manifold insulator foam.
4. Install the upper intake manifold. Tighten bolts to
12 N·m (105 in.lbs.) starting in the center working
outward in a cross sequence pattern.
5. Install the right manifold support brackets. Tighten
fasteners to 12 N·m (105 in.lbs.).
6. Install the throttle bracket. Tighten fasteners to 12
N·m (105 in.lbs.) at the throttle body and 28N·m
(259 in.lbs.) at the cylinder head.
9 - 2260
ENGINE - 3.5L - SERVICE INFORMATION
LX
7. Connect the manifold tuning valve and short runner
valve electrical connectors.
8. Connect the electronic throttle control harness con-
nector.
9. Connect the engine electrical connectors to the
intake manifold.
10. Connect the EGR tube, PCV, Purge and power
brake
booster
vacuum
hoses
to
the
intake
manifold.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2261
11. Connect the MAP sensor harness connector.
12. Install the inlet hose and connect the IAT sensor
harness connector.
13. Connect negative battery cable.
9 - 2262
ENGINE - 3.5L - SERVICE INFORMATION
LX
LOWER INTAKE MANIFOLD
1. Clean all sealing surfaces.
2. Position new gaskets and intake manifold on cylin-
der head surfaces.
3. Install intake manifold bolts and gradually tighten in
sequence shown until a torque of 28 N·m (250 in.
lbs.) is obtained.
4. Install fuel rail and injectors as an assembly, (Refer
to 14 - FUEL SYSTEM/FUEL INJECTION/FUEL
INJECTOR - INSTALLATION).
5. Connect fuel supply hose to fuel rail. (Refer to 14 -
FUEL SYSTEM/FUEL DELIVERY/FUEL LINES -
STANDARD PROCEDURE)
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2263
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст