Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 240
2. Align sensor keyway with notch in top of sensor
mount on booster housing, then install pedal travel
sensor (2). The sensor will snap into place past the
retaining ring (1).
3. Connect wiring harness (6) connector to pedal
travel sensor (7).
4. Connect battery negative cable (2) to battery post.
It is important that this is performed properly. (Refer
to 8 - ELECTRICAL/BATTERY SYSTEM - STAN-
DARD PROCEDURE)
5 - 402
BRAKES - ABS SERVICE INFORMATION
LX
5. Perform Verification Test and clear any faults. (Refer to 5 - BRAKES - DIAGNOSIS AND TESTING)
6. Start vehicle and check for vacuum leaks around sensor. Correct as necessary.
LX
BRAKES - ABS SERVICE INFORMATION
5 - 403
SENSOR-STEERING ANGLE
REMOVAL
WARNING: BEFORE SERVICING THE STEERING COLUMN THE AIRBAG SYSTEM MUST BE DISARMED.
REFER TO ELECTRICAL RESTRAINT SYSTEM FOR SERVICE PROCEDURES. FAILURE TO DO SO MAY
RESULT IN ACCIDENTAL DEPLOYMENT OF THE AIRBAG AND POSSIBLE PERSONAL INJURY.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
1. Position the front wheels straight ahead.
2. Fully extend or pull out adjustable steering column.
3. Disconnect the negative (ground) cable from the battery.
4. Remove the airbag (3) from the steering wheel (1).
(Refer to 8 - ELECTRICAL/RESTRAINTS/DRIVER
AIRBAG - REMOVAL).
5. Remove the steering wheel mounting bolt (2) then
remove the steering wheel (1).
5 - 404
BRAKES - ABS SERVICE INFORMATION
LX
6. Remove the clock spring screws (1), (Refer to 8 -
ELECTRICAL/RESTRAINTS/CLOCKSPRING
-
REMOVAL).
7. Remove the steering angle sensor (3) screws.
8. Remove the steering angle sensor (1) from the col-
umn (2).
LX
BRAKES - ABS SERVICE INFORMATION
5 - 405
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст