Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1238
U0101-LOST COMMUNICATION WITH TCM
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts. Engine run time greater
than 3 seconds.
•
Set Condition:
The PCM doesn’t receive a Bus Message from the Transmission Control Module for 7 consecutive seconds.
The circuit is continuously monitored.
Possible Causes
CAN C BUS FAILURE OPEN OR SHORTED CONDITION
PCM
Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic
procedures and for further possible causes.
Diagnostic Test
1.
ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read PCM DTCs.
Is the DTC active at this time?
Yes
>> Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diag-
nostic procedures and for further possible causes.
No
>> Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
9 - 976
ENGINE ELECTRICAL DIAGNOSTICS
LX
U0103-LOST COMMUNICATION WITH ELECTRIC GEAR SHIFT MODULE
For a complete wiring diagramRefer to Section 8W.
LX
ENGINE ELECTRICAL DIAGNOSTICS
9 - 977
•
When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts. Engine run time greater
than 3 seconds.
•
Set Condition:
The PCM doesn’t receive a Electric Gear Shift Module message over the CAN C circuit. The circuit is contin-
uously monitored.
Possible Causes
CAN C BUS FAILURE OPEN OR SHORTED CONDITION
ELECTRIC GEAR SHIFT MODULE
PCM
Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic
procedures and for further possible causes.
Diagnostic Test
1.
ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read PCM DTCs.
Is the DTC active at this time?
Yes
>> Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diag-
nostic procedures and for further possible causes.
No
>> Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
9 - 978
ENGINE ELECTRICAL DIAGNOSTICS
LX
U0121-LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE
For a complete wiring diagramRefer to Section 8W.
LX
ENGINE ELECTRICAL DIAGNOSTICS
9 - 979
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст