Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 525
WAGON
1. Disconnect and isolate the battery negative cable.
2. Remove the two push fasteners (1) in the liftgate
opening.
3. From inside the cargo area, using a trim stick (spe-
cial tool #C-4755) or equivalent, gently pry the
access panel off the rear of the quarter trim panel.
4. Remove the one plastic wing nut.
5. Pulling rearward, release the mounting tabs of the
tail lamp unit (1).
8L - 130
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
6. Disconnect the electrical connector (3) from tail
lamp unit (1).
1. Twist counterclockwise to remove the Stop (1),
Turn Signal (2), or Back-Up lamps.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 131
INSTALLATION
SEDAN
1. Position the tail lamp unit (1) in the rear quarter
panel of vehicle.
2. Install and tighten the three plastic wing nuts (3).
3. From within the trunk, connect the electrical con-
nector (1) to tail lamp unit (2).
4. Replace trunk carpeting.
5. Connect the battery negative cable.
8L - 132
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
WAGON
1. Connect the electrical connector (3) to the tail lamp
unit (2).
2. Position the tail lamp unit (2) in quarter panel open-
ing.
3. Give a firm push forward to seat the indexing pins.
4. Install and tighten the one plastic wing nut.
5. Install the two push pin fasteners (1) in the liftgate
opening.
6. Connect the battery negative cable.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 133
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст