Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 113
9. Remove rear axle forward mount isolator (1) bolt/
nut (2).
10. Remove two rear axle-to-crossmember bolts (1).
11. Carefully lower rear axle. While lowering axle,
separate propeller shaft from axle and support
with suitable rope or wire (1).
3 - 184
REAR AXLE - 210RII
LX
12. Lower axle just enough to remove both halfshafts
one at a time. Shift axle assembly in one direc-
tion, compressing one halfshaft while removing
the other (1). Use caution to protect axle seal and
journal.
13. Remove axle assembly from vehicle and transfer
to bench.
14. Using suitable screwdriver, remove axle seals and
discard.
LX
REAR AXLE - 210RII
3 - 185
INSTALLATION
1. Install new axle seal(s) (1) using Tool 9223 (2).
NOTE: Use care when installing halfshaft to axle
assembly. The halfshaft installation angle should
be minimized to avoid damage to seal upon instal-
lation.
2. Using new circlip(s), install halfshaft (1) to rear axle
assembly. Use care not to damage axle seals(2).
Verify proper installation by pulling outward on joint
by hand.
3 - 186
REAR AXLE - 210RII
LX
3. Raise rear axle assembly into position. Align pro-
peller shaft index marks (3) and start propeller
shaft coupler-to-axle bolt/nuts by hand.
4. Install two rear axle-to-crossmember bolts (1) and
torque to 220 N·m (162 ft. lbs.).
5. Install rear axle front mount isolator (1) as shown
and torque bolt/nut to 65 N·m (48 ft. lbs.).
LX
REAR AXLE - 210RII
3 - 187
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст