Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1690
CAUTION: Always install the new timing chain with
the oil holes pointing up. Failure to do so will
result in severe engine damage.
NOTE: Always keep new timing chain meshed with
camshaft sprocket.
CAUTION: DO NOT CRANK ENGINE and DO NOT
ROTATE ENGINE BACKWARD. Engine rotation is
clockwise, as you are looking at the engine.
Rotate engine at crankshaft only.
NOTE: Draw out the end of old timing chain evenly
as it becomes free, to the same extent that new
timing chain is drawn in.
2. Draw in new timing chain with the oil holes facing
up, by rotating the crankshaft slowly in direction of
rotation of engine.
.
3.
Rotate the engine until the ends of the new timing
chain meet and can be connected.
9 - 2784
ENGINE - 3.0L TD SERVICE INFORMATION
LX
NOTE: Assembly link is only an assembly aid and
NOT designed for engine running.
4. Remove assembly locking element, assembly outer
plate and assembly link.
CAUTION: Cover timing case recesses to prevent
foreign material from entering engine.
5. Insert new riveted link with the oil hole up, and new
middle plate into ends of timing chain using the
guide link to hold the middle plate in position.
NOTE:
When
assembling
riveting
tool,
piece
#9312–7 is secured by a screw and #9312–10 can
move loosely on thrust spindle
6. Assemble riveting tool by inserting pieces #9312–7
and #9312–10.
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2785
NOTE: Ensure that the riveted link and riveting
tool are aligned.
7. Press in new riveted link as far as the stop.
8. Remove guide link and riveting tool to change
inserts.
9. Install insert #9312–6 on riveting tool and secure
with screw.
10. Install insert 9312–8 on riveting tool.
NOTE: The outer plate is held magnetically by riv-
eting tool.
11. Insert new outer plate into the moving assembly
insert.
12. Position riveting tool so that spacer webs of the
guide are side by side.
13. Ensure that riveted link and outer plate are
aligned.
NOTE: When turning spindle of riveting tool, be
sure that pins of riveted link are inserted into
holes of outer plate
14. Screw in spindle of riveting tool until firm resis-
tance is felt.
9 - 2786
ENGINE - 3.0L TD SERVICE INFORMATION
LX
15. Remove riveting tool.
16. Install
moving
assembly
insert
#9312–11
to
#9312–1.
17. Position riveting tool exactly over middle of pin.
18. Tighten riveting tool spindle to end of travel.
19. Repeat procedure for both riveting pins.
20. Inspect riveting, re-rivet if required.
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2787
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст