Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1573
Oil Pressure Gauge C-3292
Piston Ring Compressor C-385
Pressure Tester Kit 7700
Rear Crankshaft Seal Installer 8349
Rear Crankshaft Seal Remover 8506
Valve Spring Compressor C-3422-B
Valve Spring Tester C-647
Adapter, Valve Spring Compressor Off-vehicle 8464
9 - 2316
ENGINE - 5.7L SERVICE INFORMATION
LX
ENGINE SUPPORT FIXTURE 8534
ENGINE LIFT FIXTURE AND ADAPTER
VALVE SPRING COMPRESSOR 9065A
PUSHROD RETAINING PLATE - 9070
FRONT CRANK SEAL REMOVER - 9071
FRONT CRANK SEAL INSTALLER 9072
LX
ENGINE - 5.7L SERVICE INFORMATION
9 - 2317
AIR INTAKE SYSTEM
REMOVAL
Filter Element Only
Housing removal is not necessary for element (filter)
replacement.
1. Loosen clamp and disconnect air duct at air
cleaner cover.
2. Pry over 4 spring clips (5) from housing cover (3)
(spring clips retain cover to housing).
3. Release housing cover (3) from locating tabs (4) on
housing and remove cover (3).
4. Remove air cleaner element (filter) from housing.
5. Clean inside of housing before replacing element.
Housing Assembly
1. Loosen clamp and disconnect air duct at air
cleaner cover.
2. Lift entire housing (1) assembly from 4 locating
pins (2).
9 - 2318
ENGINE - 5.7L SERVICE INFORMATION
LX
INSTALLATION
1. Install filter element into housing.
2. Position housing cover into housing locating tabs
(4).
3. Pry up 4 spring clips(5) and lock cover to housing.
4. Install air duct to air cleaner cover and tighten hose
clamp to 3 N·m (30 in. lbs.) torque.
5. If any other hose clamps were removed from air
intake system, tighten them to 3.4 N·m (30 in. lbs.)
torque.
6. If any bolts were removed from air resonator hous-
ing or air intake tubing, tighten them to 4.5 N·m (40
in. lbs.) torque.
7. Install filter housing (1) into locating pins (2).
LX
ENGINE - 5.7L SERVICE INFORMATION
9 - 2319
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст