Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1493
SEAL-CRANKSHAFT REAR OIL
REMOVAL
The crankshaft rear oil seal is incorporated in the seal
adapter (2) and can not be removed from the adapter.
The crankshaft rear oil seal/seal adapter (2) are ser-
viced as an assembly.
1. Disconnect negative battery (1) cable.
9 - 1996
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
2. Raise vehicle.
3. Remove splash shield retaining bolts (1) and
splash shield (2).
4. Remove the structural collar (Refer to 9 - ENGINE/
ENGINE
BLOCK/STRUCTURAL
COVER
-
REMOVAL).
5. Remove transmission (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/AUTOMATIC
-
42RLE
-
REMOVAL).
6. Remove flex plate attaching bolts (2), backing plate
(3), and flex plate (1).
7. Remove oil pan (Refer to 9 - ENGINE/LUBRICA-
TION/OIL PAN - REMOVAL).
NOTE: The integrated stamped steel rear crank-
shaft seal is not interchangable with the cast alu-
minum rear seal adapter and seal assembly.
8. Remove seal retainer attaching screws.
9. Remove crankshaft rear oil seal/adapter (2).
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1997
INSTALLATION
NOTE: The integrated rear crankshaft seal (2) is
not interchangeable with the cast aluminum rear
seal adapter and seal assembly.
NOTE: Inspect the crankshaft to make sure no
nicks or burrs are on the seal surface.
1. Clean sealing surfaces thoroughly.
2. Apply engine oil to the seal lip inside diameter.
NOTE: The seal lip (2) on the retainer must always
uniformly curl inward toward the engine on the
crankshaft (1).
9 - 1998
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
3. Position the special tool 6926 (1) onto the crank-
shaft and gently slide the seal (2) over the crank-
shaft.
4. Install seal retaining bolts finger tight.
NOTE: The following steps must be performed to
prevent oil leaks at sealing joints.
5. Attach Special Tools 8225 (1) to pan rail using the
oil pan fasteners.
NOTE: Make sure that the “2.7L” stamped on the
special tool is facing the cylinder block (flat side
of tools against pan rail).
NOTE: Make sure that the seal flange is flush with
the block oil pan sealing surface.
6. While applying firm pressure to the seal assembly
(2) against Special Tools 8225 (1), tighten seal
assembly screws to 12 N·m (105 in. lbs.).
7. Remove special tool 8225.
8. Install oil pan (Refer to 9 - ENGINE/LUBRICATION/
OIL PAN - INSTALLATION).
9. Install flex plate (1), backing plate (3), and attach-
ing bolts (2) (Refer to 9 - ENGINE/ENGINE
BLOCK/FLEX PLATE - INSTALLATION).
10. Install transmission (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/AUTOMATIC
-
42RLE
-
INSTALLATION).
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1999
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст