Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1683
OIL PUMP
REMOVAL
OIL PUMP PICKUP TUBE
1. Disconnect negative battery cable.
2. Raise vehicle on hoist.
3. Remove oil pan (Refer to 9 - ENGINE/LUBRICA-
TION/OIL PAN - REMOVAL).
4. Remove oil pump pickup tube retaining bolt and
pull
pickup
tube
from
engine
block.
Discard
O-rings.
REMOVAL
1. Remove oil pan. (Refer to 9 - ENGINE/LUBRICA-
TION/OIL PAN - REMOVAL)
2. Remove fasteners at the oil pump cover.
3. Remove oil pump fasteners (1).
4. Remove oil pump from the crankcase.
9 - 2756
ENGINE - 3.0L TD SERVICE INFORMATION
LX
INSTALLATION
OIL PUMP PICKUP TUBE
1. Lubricate o-rings on oil pump pickup tube with
engine oil.
2. Install pickup tube in engine block and install
retaining bolt. Torque bolt to 32.4 N·m. (24 ft.lbs.).
3. Install oil pan (Refer to 9 - ENGINE/LUBRICATION/
OIL PAN - INSTALLATION).
4. Refill engine oil to proper level.
5. Connect negative battery cable.
INSTALLATION
1. Clean the strainer of the oil pump and replace seal-
ing ring. Fill oil pump with engine oil so that oil is
delivered when first starting engine.
2. Install the oil pump.
3. Install fastener for oil pump. Torque fastener to 19
N·m (14 ft. lbs.).
4. Install fastener for oil pump cover (1) with oil pipe
(2) to oil pump. Torque fastener to 12 N·m (9 ft.
lbs.).
5. Install bracket to the oil pump. Torque fastener to 9
N·m (7 ft. lbs.).
6. Install oil pan. (Refer to 9 - ENGINE/LUBRICA-
TION/OIL PAN - INSTALLATION).
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2757
OIL JET
DESCRIPTION
Three dual-nozzle oil jets are bolted to the cylinder
block underneath the main oil gallery. The jets connect
with an oil-tight fit to the main gallery through lubrica-
tion passages. Each oil jet helps cool two opposite
pistons. Proper oil jet alignment is important. Each
nozzle is designed to alternatively spray oil through
both cooling galleries within the piston. The oil spray is
aimed at one of the cooling galleries as the piston
approaches TDC. As the piston approaches BDC, the
oil spray is aimed at the adjacent cooling gallery.
REMOVAL
CAUTION: Use caution when removing and install-
ing oil jets. Damage to oil jet nozzle could cause
severe engine damage. Care must be taken not to
damage the crankshaft tone ring when removing
cylinder number four oil jet.
1. Disconnect negative battery cable.
2. Raise vehicle on hoist.
3. Remove oil pan.
4. Remove oil jet retaining bolt and remove oil jet
from engine block.
9 - 2758
ENGINE - 3.0L TD SERVICE INFORMATION
LX
INSTALLATION
CAUTION: Use caution when removing and install-
ing oil jets. Damage to oil jet nozzle could cause
severe engine damage.
1. Lubricate o-ring on oil jet.
2. Install oil jet in engine block
3. Install oil jet retaining bolt. Torque bolt to 11N·m.(96
in.lbs.).
4. Install oil pan.
5. Fill engine oil to proper level.
6. Connect negative battery cable.
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2759
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст