Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 528
3. Position the lamp lens (2) on the lamp base (1)
and firmly snap into place.
4. Connect the battery negative remote cable or insert
fuse in the PDC.
8L - 142
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
UNDERHOOD LAMP UNIT - POLICE
REMOVAL
1. Open hood, disconnect and isolate the battery neg-
ative remote terminal or pull fuse in the PDC.
2. Disconnect the wire harness connector (1) from
lamp unit (2).
3. Remove the push-pin fastener attaching underhood
lamp unit (2) to inner hood panel.
4. Remove the underhood lamp unit (2) from the
vehicle.
INSTALLATION
1. Position the underhood lamp unit (2) on the hood
inner panel.
2. Install the push-pin fastener attaching the lamp unit
base (2) to the inner hood panel.
3. Connect the wire harness connector (1).
4. Connect the battery negative remote cable or rein-
sert fuse in the PDC.
5. Close hood.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 143
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
TABLE OF CONTENTS
page
page
LAMPS/LIGHTING - INTERIOR - ELECTRICAL
DIAGNOSTICS
DIAGNOSIS AND TESTING
B161B-COURTESY/DOME LAMP CONTROL
CIRCUIT LOW . . . . . . . . . . . . . . . . . . . . . . . . . . . . 146
B161F-READING LAMP CONTROL CIRCUIT
LOW. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 148
8L - 144
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
LX
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
DIAGNOSIS AND TESTING
LX
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
8L - 145
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст