Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1623
11. Install spring compressor (1,3,), special tool#
9065, and exhaust adapter arm (1) tool # 9065if
needed.
NOTE: All valve springs and seals are removed in
the same manner.
12. Insert air hose (1) into spark plug hole and charge cylinder with air.
NOTE: Tap the top of the valve spring retainer to loosen the spring retainers locks.
13. Compress valve spring with valve spring compessor (3) tool # 9065and remove valve retainer locks.
14. Release spring compressor (3) and remove valve spring.
NOTE: The valve springs are interchangeable between intake and exhaust.
15. Remove valve seal.
9 - 2516
ENGINE - 6.1L SERVICE INFORMATION
LX
INSTALLATION
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2517
NOTE: The intake seal has a smaller spring seat
diameter compared to the exhaust seal.
1. Install valve seal.
NOTE: The intake spring damper has a longer free
length compared to the exhaust spring damper.
2. Install valve spring.
3. Using special tool# 9065 (1,3,), compress valve
spring and install valve spring retainer and locks.
4. Release air charge in cylinder (1).
5. Remove spring compressor tool # 9065 (3).
CAUTION: Verify that the pushrods are fully seated into lifter and rocker arm. Recheck after rocker arm
shaft has been torqued to specification.
9 - 2518
ENGINE - 6.1L SERVICE INFORMATION
LX
6. Install rocker arm shaft and pushrods (Refer to 9 -
ENGINE/CYLINDER
HEAD/ROCKER
ARM
/
ADJUSTER ASSY - INSTALLATION).
7. Tighten the rocker shaft bolts to 22 N·m (195 in.
lbs.)
torque,
using
the
rocker
shaft
torque
sequence.
8. Remove special tool# 9070, pushrod retaining plate
(1), if used.
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2519
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст