Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1664
3. Remove the air inlet tube to the turbocharger along with the air cleaner cover (2).
4. Remove the air control valve resonator (2).
5. Remove the vacuum pump (1).
6. Remove the oil level indicator fastener (4).
9 - 2680
ENGINE - 3.0L TD SERVICE INFORMATION
LX
7. Remove the PCV (1) and rear housing adaptor (2).
8. Remove the injector cover.
9. Remove the fuel rail (2).
10. Remove the high pressure fuel lines at the injec-
tors (3).
11. Disconnect the return fuel hose from the injectors.
12. Disconnect the fuel injector and camshaft position
sensor wiring harness connectors and set aside.
13. Remove the injectors.
14. Disconnect the heater hose bracket from the cyl-
inder head cover.
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2681
CAUTION: Care must be taken not to damage the
cylinder head cover. If the sealant is difficult to
separate, use a hand held heat gun and warm the
area thoroughly along the sealer bead.
NOTE: The rear camshaft seal is located inside the
PCV housing adaptor assembly.
15. Remove the cylinder head cover (3) and front seal
(4).
INSTALLATION
LEFT
1. Install the left front camshaft oil seal (2).
9 - 2682
ENGINE - 3.0L TD SERVICE INFORMATION
LX
2. Install the left rear camshaft oil seal (2).
3. Clean and inspect all sealing surfaces.
NOTE: Care must be taken not to get any engine
sealant on the camshaft journals of the cylinder
head cover.
4. Install a 1/8 in bead of Mopar Engine RTV Gen II
sealant to the underside of the cylinder head cover
(Refer
to
9
-
ENGINE
-
STANDARD
PROCEDURE).
LX
ENGINE - 3.0L TD SERVICE INFORMATION
9 - 2683
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст