Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2037
32. Remove and discard the oil pump-to-case bolts
(1). The oil pump bolts are not to be reused.
33. Remove oil pump using C-3752 Pullers (2).
34. Remove oil pump while pushing in on input shaft
(1).
21 - 682
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
LX
35. Remove oil pump gasket (2).
CAUTION: By-pass valve must be replaced if
transmission failure occurs.
36. Remove the cooler by-pass valve (1).
37. Remove the #1 caged needle bearing (1).
LX
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 683
38. Remove the input clutch assembly (1).
39. Remove the #4 thrust plate (2).
40. Remove the front sun gear assembly (1) and #4
thrust washer (if still in place).
21 - 684
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
LX
41. Remove the front carrier/rear annulus (2) and #6
needle bearing (1).
42. Remove the rear sun gear (2) and #7 needle
bearing (1).
NOTE: The number seven needle bearing (1) has
three antireversal tabs and is common with the
number five and number two position. The orien-
tation should allow the bearing to seat flat against
the rear sun gear. A small amount of petrolatum
can be used to hold the bearing to the rear sun
gear.
LX
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 685
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст